A new method for characterizing the wavelength/frequency response of tunable lasers is presented. The wavelength dependence on a driving signal is measured by means of a simple self-mixing interferometric setup, which is composed of the laser itself and a photodiode. An example of the extended-cavity laser-diode characterization is presented, and the results obtained with the new measurement method are in good agreement with the ones obtained by a standard but more complex method.
Real-time measurement of plastic film thickness during production is extremely important to guarantee planarity of the final film. Standard techniques are based on capacitive measurements, in close contact with the film. These techniques require continuous calibration and temperature compensation, while their contact can damage the film. Different optical contactless techniques are described in literature, but none has found application to real production, due to the strong vibration of the films. We propose a new structure of low-coherence fiber interferometer able to measure blown film thickness during productions. The novel fiber-optic setup is a cross between an autocorrelator and a white light interferometer, taking the advantages of both approaches.
A proximity detector based on self-mixing technique, well suited for different industrial applications, is demonstrated. Instead of using a light-source plus a detector, the proposed sensor is realized by a single laser source. Two different physical effects in the laser diode allow for a continuous detecting range, from 10 mm up to 80 mm. The main advantages of the sensor are target detection from just one point of view; multiple sensors configuration does not need optical filters; separation of source and detector is eliminated; and background rejection is intrinsically given by the self-mixing effect, which shows a sharp cut-off after the focus.
A fiber-pumped single-frequency microchip erbium laser was developed and characterized with the aim of using it in coherent Optical Time Domain Reflectometry (OTDR) measurements and sensing. The laser is pumped by a fiber-coupled 976 nm laser diode and provides 8 mW TEM00 single frequency output power at 1.54 µm wavelength, suitable for efficient coupling to optical fibers. The amplitude and phase noise of this 200 THz oscillator were experimentally investigated and a Relative Intensity Noise (RIN) control loop was developed providing 27 dB RIN peak reduction at the relaxation oscillation frequency of 800 kHz
This work describes the development of a laser instrument for measuring very-short distances with a minimum sensor size. The absolute distance measurement is obtained through a modulated self-mixing interferometer, realized with a lens-less red VCSEL laser. In a range between 2 mm and 5 mm the sensor shows a resolution of 10 µm at 6.6 kHz of acquisition rate. The sensor size is limited to the laser chip and the contacts; therefore, it is applicable also in very demanding applications, such as the diameter measurement of a hole.
This paper describes the project of an optical measurement system, an evolution of the system currently installed on the lathe for turbine palettes refinement in Ansaldo Energie, developed by the Politecnico di Milano. This article analyzes the most significant causes of errors found in designing an optical measurement system, proposing improvements that can optimize the system, both in terms of performance and reliability. The idea behind this work is to develop a system that can measure with an accuracy of $10\ \mu\mathrm{m}$ the difference of length of palettes of a turbine stadium in real time, while the turbine is turning on a refinement lathe.