Svetlana Pratskova

Dr. Svetlana Pratskova


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2022 in Metals
Verified
Journal Article
Open access
PDF file
SPSvetlana Pratskova
Svetlana Pratskova
OSOlga Samoilova
Olga Samoilova
EAEgor Ageenko
Egor Ageenko
Nataliya ShaburovaNataliya Shaburova
Nataliya Shaburova
Ahmad Ostovari MoghaddamAhmad Ostovari Moghaddam
Ahmad Ostovari Moghaddam
ETEvgeny Trofimov
Evgeny Trofimov
The electrochemical behavior of as-cast AlxCoCrFeNiM (M = Ti, V, Si, Mn, Cu) high entropy alloys (HEAs) in 1 M NaCl and 0.5 M H2SO4 solutions is studied. Polarization measurements were carried out in a standard three-electrode electrochemical cell with a platinum auxiliary electrode using a P-30J potentiostat device. The potentials were measured relative to a saturated silver chloride reference electrode EVL-1M3 at room temperature (25 °C) with a sweep rate of 5 mV/s. It is shown that despite a wide passivation region, Al0.5CoCrFeNi1.6Ti0.7 HEA undergoes significant corrosion in both sodium chloride and sulfuric acid solutions and exhibits low corrosion potential and current density. Energy-dispersive X-ray spectroscopy (EDS) analysis revealed that Ti-containing eutectic areas are the most susceptible regions to corrosion. Intergranular corrosion was found in Al0.25CoCrFeNiMn and Al0.25CoCrFeNiCu HEAs. Moreover, Al0.25CoCrFeNiCu possesses the smallest passivation interval ΔE among all the investigated HEAs. For samples with Ti, Mn, and Cu, a protective film layer is not formed on the surface of the phases enriched in these elements, or it is brittle and crumbles. For samples with Si and V, a passivating film is formed. Thus, Al0.45CoCrFeNiSi0.45 and Al0.25CoCrFeNiV HEAs exhibited the highest resistance in 1 M NaCl and 0.5 M H2SO4 corrosive environments, respectively.

7 October 2023 in Metals
Verified
Journal Article
Open access
PDF file
OSOlga Samoilova
Olga Samoilova
SPSvetlana Pratskova
Svetlana Pratskova
ISIlsiya Suleymanova
Ilsiya Suleymanova
Nataliya ShaburovaNataliya Shaburova
Nataliya Shaburova
Ahmad Ostovari MoghaddamAhmad Ostovari Moghaddam
Ahmad Ostovari Moghaddam
ETEvgeny Trofimov
Evgeny Trofimov
The effect of minor platinum alloying on the microstructure, phase composition, oxidation and corrosion resistance of Al0.25CoCrFeNi high-entropy alloy (HEA) has been studied. It was observed that Pt does not segregate as a separate phase, but it is incorporated into the fcc solid solution. High-temperature oxidation of the as-cast Al0.25CoCrFeNi and Al0.25CoCrFeNiPt0.1 high-entropy alloys was carried out in a muffle furnace under isothermal conditions at 900 °C for 0–50 h (weighing was carried out every 10 h) in air atmosphere. The specific weight gain decreased from 0.58 mg/cm2 for Al0.25CoCrFeNi to 0.31 mg/cm2 for the platinum-doped Al0.25CoCrFeNiPt0.1 sample. It was determined that Pt triggers the formation of an interlayer Al-rich oxide phase between the outer Cr-rich oxide layer and the interior of the alloy, significantly reducing the oxidation rate of Al0.25CoCrFeNiPt0.1 HEA. Electrochemical tests in 0.5 M H2SO4 solution demonstrated passive behavior with anodic control of the process.

7 May 2023 in Materials
Verified
Journal Article
Open access
PDF file
OSOlga Samoilova
Olga Samoilova
SPSvetlana Pratskova
Svetlana Pratskova
Nataliya ShaburovaNataliya Shaburova
Nataliya Shaburova
Ahmad Ostovari MoghaddamAhmad Ostovari Moghaddam
Ahmad Ostovari Moghaddam
ETEvgeny Trofimov
Evgeny Trofimov
The electrochemical behavior of the as-cast Al0.5CoCrFeNiCuxAgy (x = 0.25, 0.5; y = 0, 0.1) high-entropy alloys (HEAs) in a 0.5M H2SO4 solution was studied. Polarization measurements were carried out in a standard three-electrode electrochemical cell at room temperature using a platinum counter electrode and a saturated silver chloride reference electrode. For Al0.5CoCrFeNiCu0.5 and Al0.5CoCrFeNiCu0.5Ag0.1, copper segregation along the grain boundaries was observed, which highly dissolved in the sulfuric acid solution and resulted in low corrosion resistance of the samples. Introducing Ag into Al0.5CoCrFeNiCu0.25 HEA led to the precipitation of a copper–silver eutectic structure, in which the copper regions were selectively dissolved in the sulfuric acid solution. Al0.5CoCrFeNiCu0.25 exhibited the best corrosion resistance with the corrosion current density of Icorr = 3.52 ± 0.02 μA/cm2, significantly superior to that of the Al0.5CoCrFeNi sample without copper and silver (Icorr = 6.05 ± 0.05 μA/cm2). Finally, the results indicated that suppressing elemental segregation by annealing or tailoring chemical composition is essential to improve the corrosion resistance of Al0.5CoCrFeNiCuxAgy HEAs.

6 August 2025 in Materials
Verified
Journal Article
Open access
PDF file
OSOlga Samoilova
Olga Samoilova
SPSvetlana Pratskova
Svetlana Pratskova
Nataliya ShaburovaNataliya Shaburova
Nataliya Shaburova
Ahmad Ostovari MoghaddamAhmad Ostovari Moghaddam
Ahmad Ostovari Moghaddam
ETEvgeny Trofimov
Evgeny Trofimov
The microstructure, phase composition, and high-temperature oxidation resistance of Fe-free AlCoCrNiNb0.2 and AlCoCr0.5NiNb0.2 high-entropy alloys (HEAs) were investigated. In the as-cast HEAs, niobium was found to mainly release as a Laves phase in the interdendritic region, and its solubility in the dendrites of the BCC solid solution was about 2 at.%. Both samples exhibited parabolic behavior during 100 h oxidation at 1000 °C and 1100 °C. The AlCoCrNiNb0.2 alloy demonstrated higher resistance to high-temperature oxidation compared to AlCoCr0.5NiNb0.2. The specific weight changes after 100 h of isothermal holding at 1000 °C and 1100 °C were 0.65 mg/cm2 and 1.31 mg/cm2, respectively, which are superior compared to the Fe-containing HEAs. Cr was revealed to play an important role in the oxidation behavior of the HEAs, decreasing the parabolic oxidation rate constant and increasing the activation energy of the oxidation process in the alloys.

10 December 2019 in ChemChemTech
Verified
Journal Article
Open access
PDF file
SPSvetlana Pratskova
Svetlana Pratskova
VBVladimir A. Burmistrov
Vladimir A. Burmistrov
ASAnna A. Starikova
Anna A. Starikova
Оксидные расплавы системы CaO–Al2O3–SiO2 являются основой металлургических шлаков. Поэтому термодинамические свойства этой системы неоднократно исследовались экспериментально, а также предпринимались попытки их теоретического описания. Выполнено термодинамическое моделирование диаграмм состояния двойных систем CaO–Al2O3, CaO–SiO2, Al2O3–SiO2, а также тройной системы CaO–Al2O3–SiO2. В ходе работы выведены выражения для термодинамического описания активностей компонентов оксидного расплава данной системы. Для расчета использовалась обобщенная теория регулярных ионных растворов. Определены энергетические параметры теории, зависящие от температуры и состава раствора, с помощью экспериментальных данных по теплотам и температурам плавления оксидов кальция, алюминия и кремния. По результатам проведенного моделирования определены координаты точек нонвариантных превращений на фазовых диаграммах исследуемых двойных и тройной систем. Полученные результаты по термодинамическому моделированию координат линий ликвидуса фазовых диаграмм двойных систем CaO–Al2O3, CaO–SiO2, Al2O3–SiO2 были сопоставлены с литературными данными для исследуемых систем. Расчетные диаграммы хорошо согласуются с экспериментальными, что говорит о применимости выбранной системы для описания подобных оксидных расплавов. Используемая в работе методика моделирования позволила оценить энергии Гиббса образования силикатов и алюмосиликатов кальция 3Al2O3∙2SiO2, 3CaO∙SiO2, 2CaO∙SiO2, 3CaO∙2SiO2, CaO∙SiO2, CaO∙Al2O3∙2SiO2, 2CaO∙Al2O3∙SiO2 на основе выведенных уравнений для активностей компонентов и рассчитанных параметров теории. Рассчитанные диаграммы позволят выяснить характер взаимодействия между компонентами системы, условия образования, состав и свойства образующихся соединений, не выделяя их из системы. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2 November 2025 in Journal of Chemical Technology and Metallurgy
Verified
Journal Article
Open access
PDF file
OSOlga Samoilova
Olga Samoilova
SPSvetlana Pratskova
Svetlana Pratskova
Nataliya ShaburovaNataliya Shaburova
Nataliya Shaburova
Ahmad Ostovari MoghaddamAhmad Ostovari Moghaddam
Ahmad Ostovari Moghaddam
SLSergey Lezhnev
Sergey Lezhnev
ETEvgeny Trofimov
Evgeny Trofimov
The microstructure, microhardness and corrosion resistance (in a 1 M NaCl solution) of as-cast AlxCoCrFeNiMo0.5 (x = 0, 0.25, 0.5) high-entropy alloys (HEAs) were studied. The as-cast samples exhibited a dendritic microstructure in which a (CrFeMo)-type molybdenum-rich σ-phase precipitated in the interdendritic space. It was determined that Al alloying increases the microhardness from 285 HV0.3 for CoCrFeNiMo0.5 HEA to 628 HV0.3 for Al0.5CoCrFeNiMo0.5 HEA. At the same time, aluminum has a negative effect on the corrosion resistance of the studied alloys, where an increase in Al concentration, increases the corrosion current by two orders of magnitude.