Emulsion aggregate mixtures (EAMs) are aggregate blends stabilized with an asphalt emulsion for pavement base layer applications. These are typically prepared using crushed aggregates and designed primarily using a tensile strength-based criteria. Advances in granular material testing technologies have led to the development of advanced resilient response characterization devices such as the University of Illinois FastCell (UI-FastCell). Simultaneously, fractionated reclaimed asphalt pavement (FRAP) and Quarry by-product (QB) materials are becoming increasingly common in pavement construction. This paper evaluates the inclusion of QB and FRAP in EAMs. First, the design of selected EAMs was performed using a combined Asphalt Academy TG2 and Anderson and Thompson mixture design approach. The selected mixtures were first assessed for Indirect Tensile Strength (ITS) and Tensile Strength Ratio (TSR) to track changes in both strength and moisture damage resistance with the inclusion of FRAP and QB. In addition, advanced anisotropic resilient characterization was performed using the UI-FastCell to assess the changes in resilient modulus and permanent deformation characteristics. Our results show significant enhancements in tensile strength, increased moisture damage resistance, and reduced permanent deformation with the inclusion of FRAP and QB materials in EAMs. The combined inclusion of 30% FRAP and 70% QB negatively affected the resilient response of the EAM; however, the inclusion of FRAP content to 50% with no QB materials improved its suitability for pavement base layer application.
23 December 2024 in Road Materials and Pavement Design
Cracking is one of the most critical distresses experienced by pavement infrastructure. Both flexible and rigid pavement cracking allow for water intrusion, which can in turn cause freeze–thaw damage and structural issues, causing premature failure. In addition, rigid pavements suffer from corrosion of reinforcing steel, which impedes the ability of the steel to resist deformation of the surface layer. One proposed technology to mitigate such cracking is the engineering of self-healing materials in pavements that can autogenously heal damage at the microscale. However, these technologies are not yet widely implemented, due to various practical issues. The following report provides a comprehensive literature review, preliminary evaluation of self-healing technology in asphalt concrete and Portland cement concrete, and future steps that can be taken to advance these technologies.
10 November 2025 in Transportation Research Record: Journal of the Transportation Research Board
Even though reclaimed asphalt pavement (RAP) has been extensively used in highway surface layers, its use in airfield pavement surfaces has been limited. This study explores the potential of using RAP by evaluating airfield hot mix asphalt (HMA) mixtures containing RAP at both the mixture and binder scales. Three laboratory-produced HMA mixtures, one control and others with 10% and 30% RAP, were designed according to the Federal Aviation Administration’s advisory circular 150/5370-10H. Typical mix performance tests were conducted, while binder tests involved the use of the poker chip test and other non-specified tests. As expected, rutting resistance was improved by including RAP, while cracking resistance decreased, with concern about mixes with higher amounts of RAP. The Illinois Flexibility Index Test sample’s fractured surface image analysis revealed that cohesive failure of the binder is the primary factor contributing to HMA mixture cracking while using RAP, assuming the same base binder and anti-stripping agent are utilized. The mixture testing framework, along with binder testing, has been shown to be effective for designing airfield mixes with RAP and serves as a baseline for future specifications.