In the present work, natural mordenite originated from volcanic soils in Greek islands, activated using HCl solution and HCl solution followed by NaOH solution, was used as support for preparing two metallic nickel catalysts (30 wt.% Ni). The catalysts were thoroughly characterized (XRF, N2 adsorption–desorption, SEM, XRD, TEM, H2-TPR, NH3-TPD) and evaluated for biodiesel upgrading to green (renewable) diesel. Double activation of natural mordenite optimized its supporting characteristics, finally resulting in a supported nickel catalyst with (i) enhanced specific surface area (124 m2 g−1) and enhanced mean pore diameter (14 nm) facilitating mass transfer; (ii) easier nickel phase reduction; (iii) enhanced Ni0 dispersion and thus high active surface; (iv) balanced population of moderate and strong acid sites; (v) resistance to sintering; and (vi) low coke formation. Over the corresponding catalyst, the production of a liquid consisting of 94 wt.% renewable diesel was achieved, after 9 h of reaction at 350 °C and 40 bar H2 pressure, in a semi-batch reactor under solvent-free conditions.
4 February 2025 in Journal of Environmental Chemical Engineering
Monometallic Ni catalysts supported on zeolites may undergo deactivation through carbon deposition and particle growth during hydrotreating. In this study, FeNi catalysts supported on modified natural mordenite (MO), with total metal loadings of 20–40 wt.%, were prepared by co-deposition–precipitation and evaluated for biodiesel conversion to green diesel. XRD and TEM analyses showed that Fe incorporation was associated with smaller Ni crystallites and a narrower particle size distribution compared with the monometallic 30Ni/MO reference. NH3-TPD measurements indicated changes in ammonia desorption behavior, particularly a reduced high-temperature contribution, while CO chemisorption revealed the highest uptake (137.5 μmol g−1) for 30FeNi/MO. Under the investigated conditions (310 °C, 40 bar H2, 9 h), this catalyst achieved approximately 99% biodiesel conversion and a 97 wt.% diesel-range hydrocarbon fraction. The product carbon-number distribution suggested a greater relative contribution of carbon-removing deoxygenation pathways following Fe incorporation, although definitive mechanistic assignments require additional evidence. Reusability tests revealed substantial deterioration in hydrocarbon production upon direct reuse. Washing and re-activation restored nearly complete biodiesel conversion but only partially recovered hydrocarbon production (66 wt.%). These findings demonstrate promising initial catalytic performance while highlighting limitations in catalyst stability and regeneration.
25 August 2026 in ACS Sustainable Chemistry & Engineering