This paper reports an evaluation of eleven oat genotypes in four environments for two consecutive years to identify high-biomass-yielding, stable, and broadly adapted genotypes in selected parts of Ethiopia. Genotypes were planted and evaluated with a randomized complete block design, which was repeated three times. The additive main effect and multiplicative interaction analysis of variances revealed that the environment, genotype, and genotype–environment interaction had a significant (p ≤ 0.001) influence on the biomass yield in the dry matter base (t ha⁻¹). The interaction of the first and second principal component analysis accounted for 73.43% and 14.97% of the genotype according to the environment interaction sum of squares, respectively. G6 and G5 were the most stable and widely adapted genotypes and were selected as superior genotypes. The genotype-by-environment interaction showed a 49.46% contribution to the total treatment of sum-of-squares variation, while genotype and environment effects explained 34.94% and 15.60%, respectively. The highest mean yield was obtained from G6 (12.52 kg/ha), and the lowest mean yield was obtained from G7 (8.65 kg/ha). According to the additive main effect and multiplicative interaction biplot, G6 and G5 were high-yielding genotypes, whereas G7 was a low-yielding genotype. Furthermore, according to the genotype and genotype–environment interaction biplot, G6 was the winning genotype in all environments. However, G7 was a low-yielding genotype in all environments. Finally, G6 was an ideal genotype with a higher mean yield and relatively good stability. However, G7 was a poor-yielding and unstable genotype. The genotype, environment, and genotype x environment interaction had extremely important effects on the biomass yield of oats. The findings of the graphic stability methods (additive main effect and multiplicative interaction and the genotype and genotype–environment interaction) for identifying high-yielding and stable oat genotypes were very similar.

The aim of the study is to evaluate the effect of Oat–field pea intercropping on the yield, nutritive value, and environmental impact of oat grown under a reduced level of nitrogen fertilisation. The trial was laid out in a randomized complete block design with the following treatments: oat-0 (oat (Avena sativa L., SRCP X 80 Ab 2291 variety) without N fertilization (urea)), oat-23 (oat fertilised with 23 kg N/ha), oat-46 (oat fertilised with 46 kg N/ha), O1P1 (oat intercropped with field pea (Pisum sativum L., local variety) a ratio of 1:1), O1P2 (oat intercropped with field pea a ratio of 1:2), and O2P1 (oat intercropped with field pea at a ratio of 2:1). All of the experimental plots received standard husbandry practices except for nitrogen fertilisation. Soil pH, organic matter, total nitrogen, available phosphorus, and organic carbon were determined before and after planting. The effect of nitrogen fertilization and intercropping of oat with field pea on carbon footprint, acidification footprint, eutrophication footprint, and human toxicity footprint was calculated for each plot. Oat-0 significantly reduced the total nitrogen content of the soil, while there was no significant effect of the other treatments. O2P1 significantly out-yielded all control groups; however, it was not significantly different from fertilisation treatments. Intercropping with field pea did not significantly increase the cost of production of dry matter, crude protein, or dry matter digestibility compared to control groups. Intercropping with field pea significantly reduced the carbon footprint, acidification, eutrophication, and human toxicity footprint compared to the control groups. Therefore, oat–field pea intercrops are recommended for the production of high-quality forage at low N input with reduced environmental impact.

Barley straw serves as livestock feed and mulch for soil and water conservation in the mixed barley-livestock systems of the Ethiopian highlands. High demand for barley straw biomass in the system creates competition between the two uses. This study aimed to identify the determinants of the utilization of barley straw for mulch and feed. Data on the production and use of barley straw were collected from 236 households using a structured questionnaire. Use of the straw for the purposes of soil mulch at three levels, 0–15% (marginal mulching), 15–35% (optimal mulching), 35–100% (over-mulching), was analyzed using a multinomial logit model. The optimal proportion of barley straw used as soil mulch was positively affected by the educational level of the household head, family size, distance between cropping land and homestead, number of equines in the household and amount of straw production. Female-headed households were more likely to mulch less than the optimal amount of barley straw. In general, the more the farmer’s exposure to formal extension, the less the proportion of barley straw used for soil mulching. This study provides guidance for the proportional utilization of barley straw. This will contribute to the design of appropriate biomass utilization strategies in barley-livestock farming systems.

The objective of this study was to investigate the fermentation characteristics and nutritional value of A. sativa genotypes ensiled either solely or in combination with P. purpureum 16791. Three different A. sativa genotypes (SRCPX80AB2806, ILRI_5527A, and ILRI_5526A) were harvested at the dough stage and ensiled solely or in combination with equal parts of P. purpureum 16791 with the addition of 3% molasses for all treatments in a completely randomized design with three replications over a period of 45 days. P. purpureum harvested at 60 days was ensiled and used as a control treatment. All treatments were evaluated for fermentation characteristics (pH, temperature, physical properties, and flieg point) and subjected to chemical analysis. The results showed that ensiling A. sativa ILRI_5527A, in combination with equal parts of P. purpureum 16791, produced the best silage with a significantly lower pH of 3.52. Optimal temperature (25 °C), nutrient losses based on the total dry matter (2.17%), gas (3.74%), and effluent (4.28%) were significantly (p < 0.0001) lower for T6 compared to the others. The dry matter recovery rate of T6 was significantly (p < 0.0001) higher than that of the others. T6 ranked first in the quality of physical properties (smell, color, mold, and texture). The highest dry matter (24%), organic matter (96.80%), crude fat (3.32%), and metabolizable energy (10.05 MJ/kg DM) were recorded for T6. The flieg score for T6 silage (96.6%) was also better than the others. In conclusion, ensiling A. sativa ILRI_5527 with equal parts of P. purpureum 16791 and the addition of 3% molasses improved fermentation characteristics and silage quality.

Twenty lambs (18 ± 0.22 kg initial weight) were blocked by weight and individually assigned into pens to evaluate the effects of barley straw variety on digestibility, growth performance and carcass characteristics. The following four treatments were tested: (1) a local barley straw (as control), (2) HB1963 (high grain and straw yields), (3) Traveller (high straw yielder), and (4) IBON174/03 (high grain yielder). A concentrate (50:50 wheat bran and noug seed cake) was offered constantly (300 DM g), whereas the straw was offered ad libitum. The digestibility trial lasted 22 days (15 days to adapt to dietary treatments and 7 days for sampling). The growth performance trial lasted 90 days. At the end, all of the lambs were slaughtered, and their carcasses were evaluated. The IBON174/03 variety had a higher (p < 0.05) intake of organic matter and crude protein, a higher dry matter and organic matter digestibility than the control, and a faster growth than the control. The feed-to-gain ratio was similar among treatments. The slaughter and empty body weights of lambs in the IBON174/03 group were higher than the control variety (p < 0.05). The present study showed that the feeding value of barley straw can differ substantially between varieties and therefore must be considered in the choice of a barley variety.

In Ethiopia, chicks are raised by broody hen, the success of which depends on the prevalence of predators. Hay box brooder was successfully used to raise layer type chicks. In this study, a total of 270 cobb, 500 broiler chicks were used to evaluate the brooding performance of electric, modified and existing hay-box brooders of 30 chick’s capacity, in completely randomized design. Chick mortality, growth, economic return and weight of internal organs were used as evaluation parameters. The results showed that, 98% of each of the electric and modified hay box groups survived to an age of 56 days. The electric, modified and existing hay box groups attained body weight of 2.3, 2.1, and 1.6 kg/head, respectively at an age of 56 days. It was calculated that Birr 74, 71 and 96 was required to raise day old broiler chicks to an age of 56 days with the use of electric, modified and existing hay box brooder respectively. The in-put and out-put analysis indicated net profit/head of Birr 51, 37 and 2.6 for the electric, modified and existing hay box groups respectively at an age of 56 days. The results obtained clearly showed that modified hay box brooder is equally productive as an electric brooder in raising broilers in Ethiopia where there is no electric power. However, study into setting up of proper input supply system (feed, vaccination, market linkage etc) is the future direction of research in the area of initiation of household broiler production with the use of hay box brooder. Key words: Broilers, brooding performance, survival rate, hay box brooder.