This study investigates the utilization of waste iron slag (WIS) as a sustainable alternative in concrete production to reduce environmental impact and preserve natural resources. The experimental investigation of WIS-incorporated concrete focused on compressive and tensile strength with machine learning (ML) models for prediction. Among the tested ML algorithms, Decision Tree (DT) and XGBoost showed the highest accuracy (R2 = 0.95135) in predicting concrete strength properties, while models like SVM and Symbolic Regression underperformed. Experimental results indicate that up to 20 % WIS replacement maintains adequate strength, whereas higher proportions reduce structural integrity. A ranking score index and cost analysis confirmed the technical and economic feasibility of using WIS in concrete. Cost analysis demonstrated substantial cost savings with 25 % WIS incorporation, confirming its economic feasibility. Integrating experimental data with ML predictions highlights WIS's potential for sustainable concrete applications, enabling optimized mix designs and reduced reliance on physical testing. Future work should address limitations, including dataset expansion and the exploration of additional durability and mechanical properties to validate WIS's practicality in construction further.
Slope stability is an essential aspect of geotechnical engineering. Unstable slopes or stable slopes influenced by external factors may result in a catastrophic disaster called a landslide. In seismically active areas with steep terrain, landslides commonly occur and are regarded as one of the most severe threats. Bangladesh has not suffered any destructive earthquakes in recent years but has a considerable risk of facing such earthquakes owing to its geological conditions. Although slope failures occurring in the Rangamati Hill Tracts of Bangladesh are mainly rainfall-induced, due to the seismic risk in Bangladesh, it is essential to assess earthquake-induced slope failure in vulnerable areas. In this study, the authors analyzed the seismic slope stability at three locations in the Rangamati Hill Tracts using pseudostatic approaches. The pseudostatic approach with the variation in seismic force based on the seismic coefficient was utilized to determine the critical conditions. Using Newmark’s rigid block method, the permanent displacements for various slope conditions were calculated for the Kobe earthquake. The analysis provided crucial insight into the state of the locations. One location has a low factor of safety (FS) value at a slope angle of 30° or greater, whereas the others have a risk of slope failure at a slope angle of 50° or greater. Newmark’s displacement analysis also showed that the slopes at location 3 have the highest displacement at a lower slope angle, with location 1 and location 2 showing relatively better results than location 3. Structural and bioengineered preventive measures are needed in this area to reduce the vulnerability of possible slope failure.
20 April 2024 in Transportation Infrastructure Geotechnology
An earthquake is a fatal natural disaster that occurs suddenly without any prior signal. Every year the world faces many earthquakes with magnitudes varying from low to high. The uncertain nature of earthquakes makes it almost impossible to predict the exact time of occurrence. So, it is necessary to take precautionary steps before an earthquake hits. To take preventive measures, a proper study of tectonic plates and faults must be done to gain insight into the study area's susceptibility. Due to the geological characteristics and tec-tonic plate activity, Bangladesh risks facing an Earthquake. Every year, Bangladesh also faces some number of earthquakes of different magnitude. This study analyzes the earth-quake events in different fault zone of Bangladesh in the last 49 years. The study showed that the Tripura Fault and Shillong Plateau are the most active among the five major faults. The frequency of these faults is higher than the other ones. Though the past earthquake magnitudes were small, it is still concerning that the Tripura fault and Shillong plateau show much more frequent seismic activities that may indicate a bigger earthquake incident in the near future. The epicenter depth of most earthquakes is within 40 km from the sur-face, which is a concerning issue because most earthquakes are shallow earthquakes that tend to have more damaging properties than deep ones.