Liang Ding

Dr. Liang Ding


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2018 in Journal of Aircraft
Verified
Journal Article
Closed access
LDLiang Ding
Liang Ding
CSChang Shi-nan
Chang Shi-nan
SYShiyu Yang
Shiyu Yang
MLMengyao Leng
Mengyao Leng

30 October 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
LDLiang Ding
Liang Ding
XYXian Yi
Xian Yi
ZHZhanwei Hu
Zhanwei Hu
XGXiang Dong Guo
Xiang Dong Guo
Icing detection is the premise and basis for the operation of aircraft icing protection system, and is the primary issue in flight safety assurance. At present, there is a lack of research methods and design reference for the layout optimization of ice detectors. Therefore, in order to simulate the real icing environment encountered by the aircraft more accurately, a large-scale icing wind tunnel was used to carry out experimental research on the icing characteristics of the sensor probes. A closed-loop experimental method including the typical condition selection, sensor array interference examination and ice shape repeatability verification was initially proposed. A stepwise optimization process and a sensitivity analysis on ambient conditions were combined to determine the optimal distribution for sensor installation. It is found that the water collection coefficient on the cylinder surface of the probe first increases and then decreases along the axial direction, reaching the extreme value at a certain position. The height of this extreme point will gradually increase with the development of the wall boundary layer, showing a variation range of 2~30 mm. Improper design may cause the sensor probe to fail to capture the point with the maximum icing thickness, affecting the sensitivity of icing detection. In addition, each probe position has different sensitivity to changes in flow parameters; the points with larger icing mass and lower sensitivity to changes in attack angle will have better detection effect. The measured data and analysis in the present work can provide a basis for the accurate design of icing sensor probes.

29 June 2023 in Energies
Verified
Journal Article
Open access
PDF file
LDLiang Ding
Liang Ding
XGXingshi Gu
Xingshi Gu
XYXian Yi
Xian Yi
CSChang Shi-nan
Chang Shi-nan
The adhesive properties of aircraft icing play an important role in guiding the design of protection systems, while the formation environment, freezing process, and measurement methods have a great impact on the mechanical characteristics of ice, leading to significant differences in the available experimental results. Therefore, to improve the proximity between the experimental simulation and the actual process of inflight ice shedding, a generation system for the water cloud environment was built and integrated with a set of rotary measuring mechanisms in this paper, allowing the adhesion strength of impact ice to be measured online. In the present test, the appearance characteristics of ice formed under different conditions were observed and analyzed, with the range of its adhesion strength determined. And the effects of freezing mode, ambient temperature, and wind speed on ice adhesion were further discussed. It can be found that the impact ice has a more irregular shape and less adhesion compared to the static ice, and this difference will grow larger with the drop in ambient temperature. In addition, the adhesion of ice first increases and then decreases with the rising ambient temperature, reaching the maximum value (0.254 MPa) around −12 °C. When the flow velocity in the test section increases, the freezing process of water on the substrate will slow down, leading to greater surface adhesion.