Xiang Dong Guo

Mr. Xiang Dong Guo


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
LDLiang Ding
Liang Ding
XYXian Yi
Xian Yi
ZHZhanwei Hu
Zhanwei Hu
XGXiang Dong Guo
Xiang Dong Guo
Icing detection is the premise and basis for the operation of aircraft icing protection system, and is the primary issue in flight safety assurance. At present, there is a lack of research methods and design reference for the layout optimization of ice detectors. Therefore, in order to simulate the real icing environment encountered by the aircraft more accurately, a large-scale icing wind tunnel was used to carry out experimental research on the icing characteristics of the sensor probes. A closed-loop experimental method including the typical condition selection, sensor array interference examination and ice shape repeatability verification was initially proposed. A stepwise optimization process and a sensitivity analysis on ambient conditions were combined to determine the optimal distribution for sensor installation. It is found that the water collection coefficient on the cylinder surface of the probe first increases and then decreases along the axial direction, reaching the extreme value at a certain position. The height of this extreme point will gradually increase with the development of the wall boundary layer, showing a variation range of 2~30 mm. Improper design may cause the sensor probe to fail to capture the point with the maximum icing thickness, affecting the sensitivity of icing detection. In addition, each probe position has different sensitivity to changes in flow parameters; the points with larger icing mass and lower sensitivity to changes in attack angle will have better detection effect. The measured data and analysis in the present work can provide a basis for the accurate design of icing sensor probes.

1 August 2024 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
BWBoyi Wang
Boyi Wang
YWYingchun Wu
Yingchun Wu
LZLetian Zhang
Letian Zhang
XHXinyuan Huang
Xinyuan Huang
XGXiang Dong Guo
Xiang Dong Guo
XWXuecheng Wu
Xuecheng Wu
The ice crystal icing in aero-engines poses a significant threat to aircraft flight safety, and investigating the correlation between ice crystal size and velocity in icing wind tunnels is essential for correlating ground tests with flight conditions. In this paper, a digital holographic particle tracking velocimetry system is developed and integrated with an icing wind tunnel, and the ice crystal size and velocity are simultaneously measured in experiments at four different wind speeds. The velocity difference between the ice crystal and wind has been experimentally observed, and it increases with both the ice crystal size and wind speed. The normalized velocities of the ice crystals by the wind speeds decrease with size, and the maximum velocity difference in the experiments reaches 28% of the wind speed. Additionally, quantitative correlations between ice crystal size and normalized velocity based on the power function and polynomial model are established. The relationship between the particle Reynolds number of ice crystal and size is also analyzed, resulting in the development of a model based on the power function, and the power index ranges from 1.51 to 1.64. These findings will provide valuable assistance in the calibration and commissioning of the ice crystal simulation system in icing wind tunnels, as well as in exploring the correlation between ground icing tests and flight and in developing corresponding models.

13 November 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YWYingchun Wu
Yingchun Wu
LZLetian Zhang
Letian Zhang
BWBoyi Wang
Boyi Wang
XLXiaodan Lin
Xiaodan Lin
XHXinyuan Huang
Xinyuan Huang
XWXuecheng Wu
Xuecheng Wu
Instruments for icing cloud particle characterization are prerequisite for icing wind tunnels in icing physics research and aviation certification. Yet it is challenging to measure the multiple parameters of the multiscale and multiphase icing cloud particles, especially under the extremely hostile environment. To address this issue, a holographic airborne for cloud particle imager (HACPI) has been developed for icing cloud measurement. With the merit of three-dimensional imaging of holography, HACPI has the capability of simultaneously measuring particle morphology, size distribution, median volume diameter (MVD) and liquid water content (LWC), with a graphical user interface (GUI) software for remote control and real-time processing through parallel reconstruction. Aerodynamic simulations indicate relatively uniform flow characteristics within a sampling depth of 46 mm. The developed HACPI is applied to three industrial icing wind tunnels with test section scales ranging from 0.6 m × 0.6 m to 3.0 m × 2.0 m. The elaborative designs of optical-mechanical-electronic-thermal integrations evidenced HACPI’s robust performance in high speed wind up to ~200 m/s and low static temperature down to -30°C. Results show that HACPI can accurately measure the icing clouds in the Code of Federal Regulations Title 14 Part 25 Appendix C, the bimodal supercooled large droplet conditions in Appendix O, and the ice crystals in the Code of Federal Regulations Title 14 Part 33 Appendix D, with accuracies verified by side-by-side comparisons to certificated commercial instruments. HACPI has demonstrated to be a powerful instrument for icing cloud measurement in icing wind tunnels, and can be extended to other ground simulation facilities as well as aviation certification.

1 January 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
XWXinhao Wang
Xinhao Wang
YWYingchun Wu
Yingchun Wu
BWBoyi Wang
Boyi Wang
ZWZhenyu Wang
Zhenyu Wang
XGXiang Dong Guo
Xiang Dong Guo
XWXuecheng Wu
Xuecheng Wu

15 March 2026 in Aerospace
Verified
Journal Article
Open access
PDF file
LZLetian Zhang
Letian Zhang
BWBoyi Wang
Boyi Wang
YWYingchun Wu
Yingchun Wu
SLSi Li
Si Li
ZZZhiqiang Zhang
Zhiqiang Zhang
ZLZhen Liu
Zhen Liu
The cloud spatial uniformity in the test section is crucial for icing wind tunnels in aircraft icing research and airworthiness certification. To achieve uniform supercooled large droplet (SLD) icing conditions, both the spatial variation in droplet size distribution and the concentration should be considered. In this study, the spatial distribution of droplets under three SLD conditions is explored in the Aviation Industry Corporation of China Aerodynamics Research Institute (AVICARI)’s FL-61 icing wind tunnel. Measurements are conducted at 12 test points in vertical and horizontal directions using the holographic airborne cloud particle imager (HACPI) in conjunction with a two-axis traversing system. The droplet images obtained at specific test points below the test section centerline show deformation phenomena for droplets larger than 400 μm. Additionally, the aspect ratio of deformed droplets increases with droplet size. The spatial evolution of the median volume diameter (MVD) and liquid water content (LWC) is examined. For two spray arrangements where the activated nozzles are positioned close, the test point where the LWC peak in the vertical direction occurs is higher than that of the MVD peak. Further analysis focuses on the size distribution of droplets in the vertical direction. The results show that the settling effect of the droplets larger than 50 μm is evident under a flow velocity of 78 m/s. Meanwhile, the position where large droplets tend to appear lowers as the droplet size increases. Finally, the spatial uniformity of droplet size distributions at the same radial distance is discussed.

2 April 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
ZWZhenyu Wang
Zhenyu Wang
XWXinHao Wang
XinHao Wang
YWYingchun Wu
Yingchun Wu
BWBotong Wen
Botong Wen
BWBoyi Wang
Boyi Wang
XWXuecheng Wu
Xuecheng Wu
An instrument for characterizing icing cloud particles in wind tunnels is critically required to enhance the understanding of aircraft icing mechanisms. Moreover, measuring multiscale and multiphase icing cloud particles presents significant challenges, particularly under extreme environmental conditions. This work elucidates the development and validation of the Airborne Interferometric Cloud Particle Imager (AICPI). AICPI’s optical-mechanical-electronic-thermal integrated design guarantees dependable operation in icing wind tunnels. Validation experiments, conducted using a monodisperse droplet generator and a high-speed microscopic imaging system, confirmed that AICPI achieves a relative size measurement error of less than 5%. AICPI was deployed in one ambient temperature wind tunnel and two industrial icing wind tunnels with test section dimensions ranging from 0.6 m × 0.6 m to 3.0 m × 2.0 m, wind speeds up to 50 m/s and temperatures as low as -14◦C. In practical applications, AICPI detects particle sizes within the operational range of 10-200 μm. Results from wind tunnel tests demonstrate AICPI’s feasibility for particle size measurement and phase discrimination in mixed-phase cloud fields.