By using different conductivity of polyaniline as filler, a kind of poly(ionic liquid)/polyaniline composite particles was synthesized to investigate the influence of dielectric polarization rate difference between filler and matrix on the electrorheological response and flow stability of composite-based electrorheological fluids under simultaneous effect of shear and electric fields. The composite particles were prepared by a post ion-exchange procedure and then treated by ammonia or hydrazine to obtain different conductivity of polyaniline. Their electrorheological response was measured by dispersing these composite particles in insulating carrier liquid under electric fields. It showed that the composite particles treated by ammonia had the strongest electrorheological response and most stable flow behavior in a broad shear rate region from 0.5 s−1 to 1000 s−1. By using dielectric spectroscopy, it found that the enhanced electrorheological response with stable flow depended on the matching degree of the dielectric polarization rates between poly(ionic liquid) matrix and polyaniline filler. The closer their polarization rates are, the more stable the flow curves are. These results are helpful to design optimal composite-based electrorheological materials with enhanced and stable ER performance.
The preparations of crystal titanium dioxide (TiO2) are often time-consuming multistep processes involving high temperature. Rapid and efficient methods to obtain TiO2 with anatase or rutile phase are desirable. In this paper, we describe an ultrafast single-step method to obtain urchin-like rutile TiO2 particles via microwave irradiation. In the procedure, TiCl4 aqueous solution was used as a reactant and toluene was used as a solvent. It takes only a few minutes without any further heat treatment. The samples were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), and thermal gravimetric analysis (TGA). The effect of temperature, irradiation time and the ratio of precursor to solvent on the morphology and crystal structure were studied. The results show urchin-like rutile TiO2 with high stability is formed after only 5 min microwave irradiation at 135 °C.