Tianchen Li

Dr. Tianchen Li


Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 September 2017 in Coatings
Verified
Journal Article
Open access
PDF file
TLTianchen Li
Tianchen Li
YLYong Liu
Yong Liu
BLBin Liu
Bin Liu
WGWenmin Guo
Wenmin Guo
LXLiyou Xu
Liyou Xu
In the present research, the spherical FeCoCrNiMo0.2 high entropy alloy (HEA) powders with a single FCC solid solution structure were prepared by gas atomization. Subsequently, the FeCoCrNiMo0.2 coatings with a different content of oxide inclusions were prepared by air plasma spraying (APS) and high-velocity oxy-fuel spraying (HVOF), respectively. The microstructure, phase composition, mechanical properties, and tribological behaviors of these HEA coatings were investigated. The results showed that both HEA coatings showed a typical lamellar structure with low porosity. Besides the primary FCC phase, a mixture of Fe2O3, Fe3O4, and AB2O4 (A = Fe, Co, Ni, and B = Fe, Cr) was identified as the oxide inclusions. The oxide content of the APS coating and HVOF coating was calculated to be 47.0% and 12.7%, respectively. The wear resistance of the APS coating was approximately one order of magnitude higher than that of the HVOF coating. It was mainly attributed to the self-lubricated effect caused by the oxide films. The mass loss of the APS coating was mainly ascribed to the breakaway of the oxide film, while the main wear mechanism of the HVOF coating was the abrasive wear.

10 July 2018 in Entropy
Verified
Journal Article
Open access
PDF file
TLTianchen Li
Tianchen Li
BLBin Liu
Bin Liu
YLYong Liu
Yong Liu
WGWenmin Guo
Wenmin Guo
AFAo Fu
Ao Fu
QFQihong Fang
Qihong Fang
A novel metal matrix composite based on the NbMoCrTiAl high entropy alloy (HEA) was designed by the in-situ formation method. The microstructure, phase evolution, and compression mechanical properties at room temperature of the composite are investigated in detail. The results confirmed that the composite was primarily composed of body-centered cubic solid solution with a small amount of titanium carbides and alumina. With the presence of approximately 7.0 vol. % Al2O3 and 32.2 vol. % TiC reinforced particles, the compressive fracture strength of the composite (1542 MPa) was increased by approximately 50% compared with that of the as-cast NbMoCrTiAl HEA. In consideration of the superior oxidation resistance, the P/M NbMoCrTiAl high entropy alloy composite could be considered as a promising high temperature structural material.