Intermetallic alloys have traditionally been characterized by their inherent brittleness due to their lack of sufficient slip systems and absence of strain hardening. However, here we developed a single-phase B2 high-entropy intermetallic alloy that is both strong and plastic. Unlike conventional intermetallics, this high-entropy alloy features a highly distorted crystalline lattice with complex chemical order, leading to multiple slip systems and high flow stress. In addition, the alloy exhibits a dynamic hardening mechanism triggered by dislocation gliding that preserves its strength across a wide range of temperatures. As a result, this high-entropy intermetallic circumvents precipitous thermal softening, with extensive plastic flows even at high homologous temperatures, outperforming a variety of both body-centered cubic and B2 alloys. These findings reveal a promising direction for the development of intermetallic alloys with broad engineering applications.
In the present research, the spherical FeCoCrNiMo0.2 high entropy alloy (HEA) powders with a single FCC solid solution structure were prepared by gas atomization. Subsequently, the FeCoCrNiMo0.2 coatings with a different content of oxide inclusions were prepared by air plasma spraying (APS) and high-velocity oxy-fuel spraying (HVOF), respectively. The microstructure, phase composition, mechanical properties, and tribological behaviors of these HEA coatings were investigated. The results showed that both HEA coatings showed a typical lamellar structure with low porosity. Besides the primary FCC phase, a mixture of Fe2O3, Fe3O4, and AB2O4 (A = Fe, Co, Ni, and B = Fe, Cr) was identified as the oxide inclusions. The oxide content of the APS coating and HVOF coating was calculated to be 47.0% and 12.7%, respectively. The wear resistance of the APS coating was approximately one order of magnitude higher than that of the HVOF coating. It was mainly attributed to the self-lubricated effect caused by the oxide films. The mass loss of the APS coating was mainly ascribed to the breakaway of the oxide film, while the main wear mechanism of the HVOF coating was the abrasive wear.
27 September 2019 in ACS Applied Materials & Interfaces