A new concept of vertical gallium nitride (GaN) Schottky barrier diode based on nanowire (NW) structures and the principle of dielectric REduced SURface Field (RESURF) is proposed in this paper. High-threading dislocation density in GaN epitaxy grown on foreign substrates has hindered the development and commercialization of vertical GaN power devices. The proposed NW structure, previously explored for LEDs offers an opportunity to reduce defect density and fabricate low cost vertical GaN power devices on silicon (Si) substrates. In this paper, we investigate the static characteristics of high-voltage GaN NW Schottky diodes using 3-D TCAD device simulation. The NW architecture theoretically achieves blocking voltages upward of 700 V with very low specific on-resistance. Two different methods of device fabrication are discussed. Preliminary experimental results are reported on device samples fabricated using one of the proposed methods. The fabricated Schottky diodes exhibit a breakdown voltage of around 100 V and no signs of current collapse. Although more work is needed to further explore the nano-GaN concept, the preliminary results indicate that superior tradeoff between the breakdown voltage and specific on-resistance can be achieved, all on a vertical architecture and a foreign substrate. The proposed NW approach has the potential to deliver low cost reliable GaN power devices, circumventing the limitations of today's high electron mobility transistors (HEMTs) technology and vertical GaN on GaN devices.
Reduction of threading dislocation density in top-down fabricated GaN nanocolumns (NCs) via their successive lateral shrinkage by anisotropic wet etch and lateral overgrowth by metalorganic chemical vapor deposition is studied by transmission electron microscopy. The fabrication process involves a combination of dry and wet etches to produce NC arrays of a low fill factor (<5%), which are then annealed and laterally overgrown to increase the array fill factor to around 20%–30%. The resulting NC arrays show a reduction in threading dislocation density of at least 25 times, allowing for the reduction in material volume due to the array fill factor, with dislocations being observed to bend into the voids between NCs during the overgrowth process.
We have systematically studied the growth of N-polar GaN on sapphire in metal–organic vapor phase epitaxy (MOVPE) on different misoriented (0001) sapphire substrates. The key parameter was the NH flow, which affects the roughness, growth rate, crystal quality, and impurities. Most parameters show a trend reversal at a V/III ratio around 500 and show either a maximum, such as the growth rate, the sizes of hexagonal hillocks on low misorientations, the yellow luminescence and the mobility, or show a minimum such as the FWHM in X-ray diffraction, the carrier concentration, the surface roughness of large misorientations, or the blue (430 nm) luminescence. This suggests that around a V/III ratio of 500, the surface changes from a Ga-terminated Ga-adlayer surface to a N-terminated 3N-H surface. Using extremely low V/III ratios, a smooth N-polar GaN was obtained even on the standard 0.2° misorientation. However, good crystalline quality, low oxygen impurities and smooth surfaces together seem too challenging with low misorientation. The strain-dependent band edge shifted by 14 eV for strain along [000], which is close to the values reported by Ga-polar GaN.
23 May 2019 in Japanese Journal of Applied Physics
Fully functional InAlN-based ultraviolet LEDs emitting at 340–350 nm were demonstrated for the first time; detailed electrical and optical characterization is presented and discussed. Results from the measurements at pulsed conditions are in agreement with the attribution of the dominant electroluminescence peak to near-band-edge emission. The composition of the AlGaN barriers was chosen to give the same internal polarization field as that of the InAlN wells. A simulation study of this polarization-matched heterostructure shows a significant increase in the electron-hole overlap integral if compared with a standard AlGaN/AlGaN active region having the same level of carrier confinement. Limitations and problems of these preliminary devices are also presented, and possible future work aimed at increasing their efficiency is discussed.