Several techniques for cooling mass concrete structures were developed in order to increase structural integrity and reduce the influence of cement hydration, which sometimes causes cracking in concrete structures, negatively affecting their durability. This research focuses on cooling system design, initial investment, and the influence of different refrigerants on cooling system performance aims in producing higher quality massive concrete. Cooling aggregates in massive concrete structures such as desert dams can be performed by employing cooled air from an air conditioning duct system or chilled water. The experimental study illustrates the relationship between the coefficient of performance COP, the evaporator temperature, cooling capacity, and refrigerant mass flow rate as a function of the evaporator temperature, cooling capacity, and refrigerant mass flow rate. The findings of the experiments were utilized to verify a numerical model developed utilizing engineering equation solver (EES) software. The performance of the vapor compression of the cooling systems was compared using alternative refrigerants, including R22, R32, and R410a at different operating conditions. This study revealed that R22 refrigerant has a higher coefficient of performance than R32 and R410A, while R32 has the highest cooling capacity among other refrigerants.
6 August 2026 in Journal of Thermal Analysis and Calorimetry
The purpose of this study is to look at the possible benefits of putting nano ceramic coatings on photovoltaic (PV) modules in terms of efficiency and power output. The basic goals of the nano ceramics application are to enhance light absorption, minimize surface reflectance, and alleviate environmental conditions that commonly impede PV performance. Various nano ceramic materials and coating procedures are examined in a series of studies to see how they affect the overall efficiency and power production capacities of solar panels. The findings of this study are intended to provide useful insights into the optimization of solar technology, enabling the development of more sustainable and effective energy producing systems. This study supports continuing efforts to improve the performance and reliability of PV systems, providing a feasible approach for expanding solar energy use. The results demonstrate the significant benefits of adding nano ceramic coatings to PV modules. The primary advantages are a 3-5°C decrease in operating temperature, a 2-3% increase in efficiency, and a 10-12% increase in power output. These findings demonstrate how the coating may raise solar energy systems' efficiency, especially in hotter regions.
A prime instance of an absorption refrigeration system is a two-stage system, which cools a space in two phases. To attain high efficiency and increased cooling capacity, each stage makes use of a distinct absorber-refrigerant pair. In order to sustain its efficiency, the system efficiently uses the heat that is produced by renewable energy sources. In this work, an experimental evaluation of a two-stage absorption system is carried out. The study was conducted at the site in Aqaba, Jordan, in collaboration with the Jordanian Chamber of Commerce. The system uses solar heaters to heat water, which is then stored in hot water tanks. This hot water is delivered via pipes and pumps to water absorption cooling tanks, where lithium bromide absorbs heat and cools the water. A chiller further cools the chilled water, while a cooling tower dissipates any extra heat. The study focuses on precise temperature control and system adjustments to increase efficiency and compensate for any water loss. Performance evaluation focuses on the coefficient of performance (COP) and cooling capacity. The results show a direct relationship between an increase in the coefficient of performance (COP) and higher temperatures in the absorber, upper generator, and evaporator. At 20 °C absorber temperature, the COP and condenser temperature reach their maximum values of around 1.3 and 32.2 °C, respectively. The maximum COP that can be achieved at different upper generator temperatures is 1.25 at 110 °C. Furthermore, at an evaporator temperature of 8 °C, the cooling capacity reaches 412 kW, and the COP approaches 1.28. These findings are useful for commercial and industrial customers that require efficient cooling, as well as renewable energy advocates, building designers, and regulators interested in supporting sustainable cooling solutions.