Background: The photo-acceleration of bleaching gels by lights has been extensively researched. However, the induced temperature increase during this process needs to be further evaluated to prevent damage to the dental pulp. Therefore, the objective of this study was to evaluate the surface and intrapulpal temperature kinetics of different concentrations of hydrogen peroxide (HP) gels photo-accelerated by blue or violet light and infrared laser. Methods: The whitening gels at concentrations of HP35, HP15, and HP6 % were irradiated with blue and violet LED/laser on the surface of a human canine tooth. The surface temperature variation (∆Ts) was evaluated using a pH meter, while the intrapulpal temperature variation (∆Ti) was assessed using a digital thermometer at intervals of 1, 15, and 30 min. Statistical analysis was conducted using a Two-way repeated measures ANOVA test, and Bonferroni post-test was applied at a significance level of 5 %. Results: All violet LED photo-accelerated groups showed a higher increase in ∆Ts compared to the blue LED/laser groups. However, there were no significant differences between the groups for ∆Ti. Conclusion: Although the photo-acceleration of HP35 and HP15 % gels with violet LED/laser has a greater increase in surface temperature compared to HP6 % gel, the different light systems do not significantly increase the intrapulpal temperature.

The aim of this study was to evaluate the effects of mechanized final irrigation protocols (XPE, XP-Endo Finisher; XPC, XP-Clean; and ECL, Easy Clean) compared to PUI (passive ultrasonic irrigation) on the debris incidence and open dentinal tubules, and their effects on the adhesion interface after 48 h and 6 months. One hundred twenty maxillary central incisors were submitted to chemical–mechanical preparation using a rotary instrument and 2.5% sodium hypochlorite. Specimens were distributed in 4 groups (n = 30) in accordance with the mechanized final irrigation protocol: XPE, XPC, ECL, or PUI. Forty specimens (n = 10/group) were submitted to SEM analysis to evaluate the residue incidence and dentin open tubules. The other specimens were obturated using Bio-C Sealer and submitted to push-out bond strength and adhesive failure mode evaluations in the cervical, middle, and apical thirds after 48 h or 6 months (n = 10/group). Only in the apical third, ECL presented the highest residue incidence and fewer open dentinal tubules when compared to the XPE, XPC, and PUI groups (p < 0.05). In the cervical and middle root thirds, no significant differences were observed regardless of the group evaluated (p > 0.05). After 48 h, ECL resulted in the lowest bond strength only in the apical third (p < 0.05), while the XPE, XPC, and PUI groups remained similar in the cervical and middle thirds (p > 0.05). At 6 months, all groups showed lower bond strength values regardless of the root third evaluated, but ECL showed the lowest bond strength in the apical and middle root thirds when compared to the other groups (p < 0.05). The ECL protocol did not provide adequate residue removal on the apical radicular third and negatively affected the longevity of endodontic obturation using a calcium silicate-based sealer.