masaaki baba

Dr. masaaki baba

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 December 2019 in Sustainable Energy & Fuels
Verified
Journal Article
Open access
PDF file
JKJuyoung Kim
Juyoung Kim
SYSatoru Yamanaka
Satoru Yamanaka
IMIchiro Murayama
Ichiro Murayama
TKTakanori Katou
Takanori Katou
TSTomokazu Sakamoto
Tomokazu Sakamoto
YKYoonho Kim
Yoonho Kim
Waste heat is a potentially exploitable energy source but remains a problem awaiting a solution. To explore solutions for automobile applications, we investigate pyroelectric power generation from the temperature variation of exhaust gas using a novel electro-thermodynamic cycle. Niobium-doped lead zirconate titanate stannate (PNZST) ceramics were applied as pyroelectric materials, and their structural characteristics were investigated. In the driving cycle assessments (JC-08) using real exhaust gas, the maximum power generated was identified as 143.9 mW cm−3 (777.3 J L−1 per 1 cycle) over a temperature range of 150–220 °C and an electric field of 13 kV cm−1. The net mean generating power of the total driving cycle was 40.8 mW cm−3, which is the most enhanced result in our power generating systems to date and 314 times greater than our first report. Materials with sharp transition behaviors with the temperature and electric field are worthy of study with regard to pyroelectric energy harvesting materials, and their corresponding crystal and domain structures were investigated to optimize performance.

9 December 2016 in Progress in Photovoltaics: Research and Applications
Verified
Journal Article
Open access
PDF file
MBmasaaki baba
masaaki baba
KMKikuo Makita
Kikuo Makita
HMHidenori Mizuno
Hidenori Mizuno
HTHidetaka Takato
Hidetaka Takato
TSTakeyoshi Sugaya
Takeyoshi Sugaya
NYNoboru Yamada
Noboru Yamada
The “SMAC module” is a low‐cost, high‐efficiency photovoltaic module that integrates three techniques: a “SMart stack,” “Areal current matching,” and “solar Concentration.” This paper presents the result of a proof‐of‐concept study of the SMAC module conducted using device simulations and indoor experiments. The simulation results show that an SMAC module with a two‐terminal GaAs/Si tandem solar cell can achieve an efficiency of approximately 30% and superior electricity generation per unit top cell area. The performance of the GaAs/Si solar cell developed in this study is similar to that of a GaAs/InGaAsP solar cell under concentrated artificial sunlight and is consistent with the simulation results. © 2016 The Authors. Progress in Photovoltaics: Research and Applications published by John Wiley & Sons Ltd.

4 May 2015 in Advanced Energy Materials
Verified
Journal Article
Open access
PDF file
YKYoonho Kim
Yoonho Kim
JKJuyoung Kim
Juyoung Kim
SYSatoru Yamanaka
Satoru Yamanaka
ANAkira Nakajima
Akira Nakajima
TOTakashi Ogawa
Takashi Ogawa
KNKoichi Niihara
Koichi Niihara
To investigate how exhaust heat from automobiles can be converted to renewable energy, an innovative electrothermodynamic cycle is presented, which is based on temporal temperature variations, the pyroelectric effect, instead of spatial temperature gradient, and the Seebeck effect. A generating mechanism is investigated using operando time‐resolved synchrotron X‐ray diffraction. Practical energy and true energy breakeven are achieved via real engine dynamometer experiments.

23 January 2018 in IEEE Journal of Photovoltaics
Verified
Journal Article
Open access
MBmasaaki baba
masaaki baba
KMKikuo Makita
Kikuo Makita
HMHidenori Mizuno
Hidenori Mizuno
HTHidetaka Takato
Hidetaka Takato
TSTakeyoshi Sugaya
Takeyoshi Sugaya
NYNoboru Yamada
Noboru Yamada
The electrical losses due to the series resistances-the bonding resistance and sheet resistance-in a two-terminal (2T) GaAs/Si tandem solar cell that implements the areal current-matching (ACM) technique was investigated. A 2T GaAs/Si ACM tandem solar cell has a smaller top cell area and a larger bottom cell area, to achieve current matching between the top and bottom cells. The effect of the series resistances on the performance of such an ACM tandem cell was evaluated through device simulations, in which the subcell area ratio (bottom cell area / top cell area) and series resistances were varied under 1-sun and 3-sun conditions. The simulation results revealed that the optimal subcell area ratio at which the tandem cell exhibits the highest efficiency is affected mainly by the bonding resistance, due to a unique characteristic of the fill factor. A larger bonding resistance results in a smaller optimal subcell area ratio, i.e., a larger top cell area, which requires the use of a larger amount of expensive III-V materials. This trend is more prominent under 3-sun conditions. The indoor experiments conducted on an in-house 2T GaAs/Si ACM tandem cell verified the simulated results and showed that a lower external quantum efficiency (EQE) also resulted in a smaller optimal subcell area. Therefore, low bonding resistance and high EQE are of primary importance for realizing high-efficiency low-cost 2T ACM tandem solar cells.

19 May 2017 in Ferroelectrics
Verified
Journal Article
Closed access
JKJuyoung Kim
Juyoung Kim
SYSatoru Yamanaka
Satoru Yamanaka
ANAkira Nakajima
Akira Nakajima
TKTakanori Katou
Takanori Katou
YKYoonho Kim
Yoonho Kim
Hirohisa  TanakaHirohisa Tanaka
Hirohisa Tanaka
A novel electrothermodynamic cycle based on temporal temperature variations (dT/dt); the pyroelectric effect was investigated for its potential role in the use of waste heat as renewable energy. Here, we present improved generating performance with relaxer ferroelectric ceramics ((1-x)Pb(Mg2/3Nb1/3)O3-xPbTiO3 (PMN-xPT)), which are well known for their strong dielectric and pyroelectric properties near the morphotropic phase boundary. The theoretical potential was evaluated using hysteresis loops, and the generating properties were analyzed in the laboratory using an engine dynamometer. The experiments yielded a value of 0.48 mW/cm3, which is 3 times larger than that obtained previously, because of the high polarization properties.

7 February 2017 in Advanced Sustainable Systems
Verified
Journal Article
Open access
PDF file
SYSatoru Yamanaka
Satoru Yamanaka
JKJuyoung Kim
Juyoung Kim
ANAkira Nakajima
Akira Nakajima
TKTakanori Katou
Takanori Katou
YKYoonho Kim
Yoonho Kim
HTHirohisa Tanaka
Hirohisa Tanaka
In pyroelectric applications, the general figures of merit (FOMs) have been applied and reported near room temperature. We derived the modified FOMs in considering our electro‐thermodynamic cycle for the usage environment of automotive applications. The relationship between the material properties and generating performance of PZTs was investigated at various temperatures. The was suggested from FD, a FOM for a pyroelectric sensor, based on the modified pyroelectric coefficient (p); . was calculated by the change of the spontaneous polarization (PS) according to a given temperature variation during one cycle; ΔPS/ΔT (Tmax−Tmin). It was indicated that the could be effective as a FOM for the pyroelectric generating performance and the dielectric loss (tanδ ) significantly affected the generating performance in addition to under high‐temperature and electric field conditions. Furthermore, of the PZTs tested, C‐91 sample which showed the highest generating performance resulted in a generating energy of 1.3 mW cm–3 in the engine dynamometer assessment. This is 13 times greater than the generating energy reported in a previous study of C‐6 (0.1 mW cm–3).