The rapid growth of aluminum and graphite industries has generated substantial stockpiles of red mud and graphite tailings, which pose environmental risks due to their high heavy metal content and potential for soil and water contamination. This study investigated the leaching behavior of heavy metals from these materials post-stabilization using cement and a sulfonated oil-based ion curing agent, thereby evaluating their suitability for safe reuse. Semi-dynamic leaching experiments were employed to measure heavy metal release, supplemented by kinetic modeling to discern key leaching mechanisms. The findings indicated that the heavy metal concentrations in leachates were consistently below regulatory standards, with leaching dynamics influenced by dual mechanisms: the diffusion of ions and surface chemical reactions. A diffusion coefficient-based analysis further suggested low leachability indices for all metals, confirming effective immobilization. These results suggest that cement and curing agent-stabilized red mud–graphite tailing composites reduce environmental risks and possess characteristics favorable for resource recovery, thus supporting their sustainable use in industrial applications.
Glass fibers are widely used in cement-based precast products, given the reinforcing requirements for toughness and strength. However, inferior alkali resistance hinders the effectiveness of glass fibers in reinforcing cement-based materials. In this paper, nanoparticle coatings were applied on the surface of alkali-resistant glass fiber (ARGF) as a protective layer via the in situ chemical reaction of oleic acid (OA) and potassium permanganate (PP). The morphology and constituents of the as-prepared ARGFs were examined using scanning electron microscopy (SEM) and obtaining X-ray photoelectron spectroscopy (XPS) measurements. Mass loss and strength retention were investigated to characterize alkali resistance of modified ARGFs. Results showed that ARGFs could be optimally coated by a layer of MnO2-based nanoparticles consisting of approximately 70% MnO2, 18% MnO, and 12% MnSiO3, when modified with an optimum OA to PP ratio of 10 for 24 h. The dissolution of ARGFs matrix in 4% and 10% NaOH solutions were distinctly delayed to 28 d, as a consequence of the introduction of the MnO2-based nanoparticle layer, compared with nontreated ARGF occurring at 3 d in 4% NaOH solution. For the optimally modified ARGFs, the mass loss was controlled to 1.76% and 2.91% after 90 d of corrosion in 4% and 10% NaOH solutions, and the retention of tensile strength was increased by approximately 25%. With respect to the increment in alkali-resistant performance, the modified ARGFs can be promising candidates for wide applications in alkaline cement-based products.