Photonic crystals based on anodic aluminum oxide films are examined as refractive index sensors for controlling the composition of water-alcohol liquid mixtures. The position of the reflectance maximum corresponding to the first photonic stop band is used as the analytical signal. Impregnation of a photonic crystal with water-ethanol and water-glycerol mixtures results in a redshift of the reflectance maximum. A fairly high refractive index sensitivity, sufficient to determine the composition of water-ethanol and water-glycerol mixtures with an accuracy of about 1 wt.%, is observed. The detailed dependencies of the analytical signal on the composition of mixtures are experimentally investigated and compared with numerical calculations. Prospects and limitations of the refractive index sensors based on anodic alumina photonic crystals are discussed.
8 April 2020 in Physical Chemistry Chemical Physics
Inverse opal films impregnated with a methylene blue dye were prepared by a template route. Photonic stop band governs amplitude of spontaneous Raman scattering peaks for metal-free photonic crystals, enhancement factor being over 50.
1 March 2020 in Journal of Physics: Conference Series
Inverse photonic crystal films were prepared by photopolymerization of ethoxylate trimethylolpropane triacrylate (ETPTA) using opal-type templates. Their high quality was proved by investigations of structural and optical properties. The unexpectedly high refractive index, nETPTA ≈ 1.67, of polymerized ETPTA was obtained from a numerical approximation of the spectral positions of the reflectance peak of the films at different incidence angles. Fabricated samples were tested as sensors for water-ethanol mixtures, and a monotonous increase in the stop band shift with an increase in ethanol concentration was established.
24 August 2021 in Physical Chemistry Chemical Physics
The detection limit of methylene blue of about 10 −7 M was achieved by measuring Raman scattering of light at a laser wavelength that coincides with the photonic stop band of a composite substrate consisting of inverse opal with gold nanoparticles.
27 September 2023 in Crystal Research and Technology
Smart photonic indicators (SPIs) offer a cost‐effective and efficient way to monitor and control ethanol concentration, making them suitable for advanced digital informatics systems. The developed sensors can operate even after the removal of external stimuli, featuring exceptional optical memory and reconfigurable nanostructures, which will undoubtedly drive a revolution in colorimetric sensors. The SPI is prepared by polymerizing mixed monomers of poly(ethylene glycol) diacrylate (PEG600DA) and ethoxyethoxyethyl acrylate (EOEOEA) in a silica colloidal crystal template. SPIs contain periodically ordered interconnecting macropores via shape memory polymers (SMPs) that endow the films with structural colors. The evaporation of water can temporarily deform the initial periodic structure. The structure can then be restored by evaporating liquids with lower surface tension, such as water‐ethanol solutions. The Laplace pressure generated during solvent evaporation competes with the elasticity of SMPs, driving nanoscale structural transformation. Consequently, the detection range of SPIs for ethanol concentration in water depends on the balance between these two driving forces. Adjusting the size of the macropores expands the detection range allowing differentiation of alcohol concentrations from 5% to 100%. SPIs with selectivity and high sensitivity hold promise for various applications, including information technology, inkless writing, and anticounterfeiting, enhancing the versatility of photonic materials.