The pyrolysis of vegetable oil waste is an alternative way to convert biomass into high-quality second-generation biofuels, with social, economic and environmental sustainability. The present work deals with the pyrolysis of oleic acid as a model compound and an industrial vegetable oil residue on CuNiAl mixed oxide catalysts, derived from layered double hydroxides. Reactions of the oils pre-adsorbed on the catalysts (catalyst:oil mass ratio of 5:1) were performed at 550 °C on a micro-pyrolysis system and the analyses of volatile products were carried out online using GC/MS. Copper addition to NiAl catalysts increased the cracking of oleic acid. Increasing copper content also decreased the formation of aromatics and coke precursors, as well as oxygenated compounds. The CuNiAl catalyst with a Cu/Ni ratio of 0.4 showed strong catalytic activity in the conversion of an industrial vegetable oil residue with a high volume of free fatty acids produced. Compared to the non-catalytic reaction, the catalyst reduced the content of oxygenates and increased the content of hydrocarbons, particularly in the gasoline range (C5–C9). The CuNiAl oxide catalyst was able to convert vegetable oil residues into hydrocarbons in the range of gasoline, kerosene and diesel, and also linear alkylbenzenes as chemical precursors for surfactant production.
The chemical recycling of poly(ethylene terephthalate) (PET) residues was performed via glycolysis with ethylene glycol (EG) over Mg-Fe and Mg-Al oxide catalysts derived from layered double hydroxides. Catalysts prepared using the high supersaturation method (h.s.c.) presented a higher surface area and larger particles, but this represented less PET conversion than those prepared by the low supersaturation method (l.s.c.). This difference was attributed to the smaller mass transfer limitations inside the (l.s.c.) catalysts. An artificial neural network model well fitted the PET conversion and bis(2-hydroxyethyl) terephthalate (BHET) yield. The influence of Fe in place of Al resulted in a higher PET conversion of the Mg-Fe-h.s.c. catalyst (~95.8%) than of Mg-Al-h.s.c. (~63%). Mg-Fe catalysts could be reused four to five times with final conversions of up to 97% with reaction conditions of EG: PET = 5:1 and catalyst: PET = 0.5%. These results confirm the Mg-Fe oxides as a biocompatible novel catalyst for the chemical recycling of PET residues to obtain non-toxic BHET for further polymerization, and use in food and beverage packaging.
Energy cane is a genotype derived from species of sugarcane (Saccharum officinarum and Saccharum spontaneum) with a lower sucrose content and higher fiber content for bioenergy purposes. It is a rustic plant that demands less fertile soils that do not compete with food crops. In this work, an analysis of energy cane bagasse pyrolysis products was performed, assessing the effect of reaction temperature and kinetic and thermodynamic parameters. Anhydrosugars, such as D-allose, were the primary compounds derived from the decomposition of energy cane at 500 °C. Methyl vinyl ketone and acetic acid were favored at 550 and 600 °C. At 650 °C, methyl glyoxal, acetaldehyde and hydrocarbons were favored. Among the hydrocarbons observed, butane, toluene and olefins such as 1-decene, 1-undecene, 1-tridecene and 1-tetradecene were the most produced. The Friedman isoconversional method was able to determine the average activation energies in the ranges 113.7−149.4, 119.9−168.0, 149.3−196.4 and 170.1−2913.9 kJ mol−1 for the decomposition of, respectively, pseudo-extractives, pseudo-hemicellulose, pseudo-cellulose and pseudo-lignin. The thermodynamic parameters of activation were determined within the ranges of 131.0 to 507.6 kJ mol−1 for ΔH, 153.7 to 215.2 kJ mol−1 for ΔG and −35.5 to 508.8 J mol−1 K−1 for ΔS. This study is very encouraging for the cultivation and use of high-fiber-content energy cane bagasse, after sucrose extraction, to produce biofuels as an alternative to the current method of conversion into electricity by low-efficiency burning.
Neste trabalho, no contexto de meio poroso com restrição de incompressibilidade, é preparada uma base preliminar de informações para o estudo de grandezas arbitrárias e constitutivas de uma suspensão particulada. São determinadas duas soluções exatas de um sistema de equações do movimento da suspensão particulada. As duas soluções são arrumadas em modelagem matemática do movimento gravitacional de suspensões particuladas em proveta, a qual envolve sub-regiões que variam com o tempo e são delimitadas por interfaces em movimento, inclusive pela onda de aceleração. Uma solução é encaixada na região de sedimentação livre e a outra na região de transição. Os movimentos da onda e das interfaces são estabelecidos pela compatibilização da solução exata da região de sedimentação livre com a solução exata da região de transição, os quais dependem dos parâmetros velocidade da onda de aceleração, ponto de encontro da onda com a interface superior descendente e ponto de encontro das interfaces. Das soluções exatas e dos movimentos são estabelecidas duas funções velocidades que servem como base para o cálculo de tais parâmetros, juntamente com o uso de dados experimentais da literatura de altura versus tempo da interface superior descendente do próprio teste de proveta. Com isso, é estabelecida uma base preliminar de informações para o estudo do movimento de uma suspensão particulada com restrição de incompressibilidade. São mostrados resultados sobre o cálculo numérico da velocidade da onda de aceleração, do ponto de encontro da onda com a interface superior descendente e do ponto de encontro das interfaces.
O alto consumo do açaí no Brasil tem gerado resíduos que podem ser convertidos em biocombustíveis e, no entanto, são descartados. Neste trabalho, o caroço do açaí foi submetido ao processo de pirólise rápida utilizando catalisador de óxidos mistos NiFe, para avaliar sua influência nos produtos obtidos. Os resultados mostram que a utilização do catalisador favoreceu reações de desoxigenação e aumentou o rendimento de hidrocarbonetos aromáticos e alfa-alcenos, que estão na faixa da gasolina e querosene.