Coherent terahertz beams with radial polarization of the 1st, 2nd, and 3rd orders have been generated with the use of silicon subwavelength diffractive optical elements (DOEs). Silicon elements were fabricated by a technology similar to the technology used before for the fabrication of DOEs forming laser terahertz beams with pre-given mode content. The beam of the terahertz Novosibirsk Free Electron Laser was used as the illuminating beam. The experimental results are in good agreement with the results of the computer simulation.
With the intensive development of data transmitting and processing devices in the terahertz (THz) frequency range, an important part of which are integrated plasmonic components and communication lines, it becomes necessary to measure correctly the optical constants of their conductive surfaces. In this paper, we describe a reliable method for determining the effective permittivity εm of a metal surface from the measured characteristics (refractive and absorption indices) of THz surface plasmon polaritons (SPPs). The novelty of the method is the conduction of measurements on a metal surface with a dielectric layer of subwavelength thickness, suppressing the radiative losses of SPPs, which are not taken into account by the SPP dispersion equation. The method is tested on a number of flat “gold sputtering–zinc sulfide layer–air” structures with the use of the THz radiation (λ0 = 141 μm) from the Novosibirsk free electron laser (NovoFEL). The SPP characteristics are determined from interferograms measured with a plasmon Michelson interferometer. It is found that the method allows a significant increase in the accuracy of the εm in comparison with measurements on the same metal surface without a dielectric layer.
Terahertz surface plasmon resonance (SPR) sensors have been regarded as a promising technology in biomedicine due to their real-time, label-free, and ultrasensitive monitoring features. Different authors have suggested a lot of SPR sensors, including those based on 2D and 3D metamaterials, subwavelength gratings, graphene, and graphene nanotube, as well as others. However, one of the traditional approaches to realize high sensitivity SPR sensors based on metal diffraction gratings has been studied poorly in the terahertz frequency range. In this article, a linear metal rectangular diffraction grating with high aspect ratio is studied. The influence of the grating structure parameters on the sensor sensitivity is simulated. Effects arising from different ratios of depth and width were discovered and explained. The results show that the sensitivity can be increased to 2.26 THz/RIU when the refractive index range of the gas to measure is between 1 and 1.002 with the resolution .
23 April 2020 in Journal of the Optical Society of America B
It has been experimentally shown that a rigid polyimide Kapton film of submillimeter thickness is sufficiently transparent in the frequency range of 1.2–3 THz and can be used for splitting surface plasmon polaritons (SPPs) propagating along a flat conducting surface. The transmittance and reflectance measured for SPPs excited by a free-electron laser radiation ( ) in “gold–ZnS layer–air” flat structures are in good agreement with the results of numerical simulations obtained using the rigorous coupled-wave analysis technique. Transmittance of the SPPs decreases slightly when the layer gets thicker. To minimize the SPP radiative losses emerging due to diffraction of the SPPs on the impedance discontinuity, the Kapton film should be placed normal to the guiding surface and brought in good contact with it (the gap must be less than ). The performed experiments clearly demonstrated Kapton films to be very promising for SPP beam splitting in large-scale terahertz SPP devices.