The main aim of this study was to determine key factors that regulate fire-retardant effectiveness of intumescent coatings comprising of ammonium polyphosphate, melamine, pentaerythritol, polymer binder. Fulfillment of the research objectives resulted in the development of a coating with R120 fire resistance. The expected service life of the coating is at least 15 years when applied at Z2 type of environmental conditions (indoor use). It was established that in order to provide fire resistance of around R30 it is advisable to use the styrene-acrylic polymers as binders for both water-based and organic-based intumescent systems. The ratio of target components ammonium polyphosphate/melamine/pentaerythritol in such systems should be close to 2/1/1. The coating thickness is to be 0.4-0.5 mm. To achieve higher fire resistance (R60 or more) the coating should include a vinyl acetate derivative as a binder (copolymers with ethylene or vinylversatate). Target components ratio in this case is to be close to 3.5/1/1.5, while the coating thickness should be kept at 1.6-1.8 mm. If the required class of fire resistance is above R120, coating thickness is usually to be kept above 3.5 mm. In order to achieve higher fire resistance, it is advisable to use nano-clay additives and reinforcing fibers in intumescent compositions. The obtained results were used in the development of intumescent coating, which is produced industrially and provides over R120 fire resistance of steel, which was confirmed in standardized full-scale fire tests.
31 July 2023 in Chemical Engineering Journal Advances
This paper reports a study into the effect of nanoclays on the water-resistance of the intumescent system ammonium polyphosphate/melamine/pentaerythritol/titanium dioxide/polymer (ethylene vinyl acetate (EVA) or styrene acrylate (SA). It has been established that adding nanoclay to a coating based on ethylene vinyl acetate increases the fire resistance limit of a metal plate by 30 %, and to a coating based on styrene acrylate – by 50 %. At the same time, coatings that include the EVA polymer are characterized by greater fire-retardant efficiency and less water resistance than coatings containing the SA polymer. It has been shown that intumescent coatings, regardless of the nature of the polymer, under the conditions of 80 % humidity over 800 days their reduce fire-protective properties by an average of 10 %. The loss of coating fire resistance occurs due to the leaching of pentaerythritol, ammonium polyphosphate, and polymer degradation by hydrolysis. The admixtures of nanoclays with a high degree of exfoliation to the studied system create a barrier effect and maximize the chemical formulation of the intumescent coating. The fireproof properties of coatings with organically-modified montmorillonite admixtures are maintained or reduced to 5 % under the conditions of 80 % humidity over 800 days. It has been determined that the direct effect of water on the coating over a period of more than 2 days leads to a significant decrease in the swelling coefficient of intumescent coatings, regardless of the content of a nanoclay admixture in their composition. At the same time, the half-decay period of coatings without nanoclay, calculated on the basis of solubility constant in water, is 0.5 days. For coatings, which include the admixtures of organically-modified nanoclays, the half-decay period increases to 2 days. The results reported in this paper could be recommended for designing water-proof fire-resistant reactive-type nano-coatings with prolonged service life.
Purpose. Study of influence of blowing agents amines structure on the construction processes of thermal insulating char layer of intumescent system ammonium polyphosphate/pentaerythritol/amine and fire protection efficiency of this system at high temperatures. Methodology. A fire retardant mixture of ammonium polyphosphate/pentaerythritol/amine was chosen as a model intumescent system. Dispersion of vinyl acetate copolymer with vinyl ether of versatic acid was used as a polymeric component. A step-by-step study of the characteristics of the char layer of the intumescent composition was applied in the study, consisting in the analysis of the characteristics of the char formed after keeping the intumescent composition samples at a certain temperature between 100 and 800 °C, char residue mass (m, %), structure and density of the formed char layer. The method of infrared spectroscopy was used for identification of products of thermolysis of intumescent systems. Determination of fire protection efficiency of intumescent coatings was carried out in a mini-oven under standard fire conditions. Findings. The influence of the structure of amines blowing agents on the formation of char layer of intumescent system ammonium polyphosphate/pentaerythritol/amine was studied. Physico-chemical parameters of char layer formed during high temperature swelling of intumescent system components with varying amine: urea, melamine, dicyandiamide, guanidine, thiocarbamide, formylthiosemicarbazide, thiosemicarbazide, phenylethylcarbamide have been determined. In the temperature range 200–400 oC for systems with linear amines (urea, thiocarbamide, thiosemicarbazide), there is a rapid formation of insulating layer with intense outgassing (high intumescent coefficients K) and the same rapid its destruction with significant losses of char residue mass (Δm). The presence of melamine, dicyandiamide and guanidine in intumescent system provides constancy of intumescent coefficient at minimal mass loss. Chemical transformations of intumescent systems were studied by the method of infrared spectroscopy when the investigated amines were varied. It was found that linear diamines do not form stable spatially branched phosphamide compounds with phosphates as the basis of a thermostable heat-insulating frame. At the same time in IR spectra of char residue systems with melamine, dicyandiamide and guanidine the absorption bands of P-N-C bonds (1070–1050 cm-1) and P-N (980–950 cm-1) up to 600–700 oC are observed. Fire tests proved that melamine, dicyandiamide and guanidine are blowing agents providing maximum protection of metal against fire and can be used for composition of fire retardants for steel constructions.Originality. It has been proved that amines in intumescent polyphosphate system perform at least two functions: blowing agents by means of thermal destruction to incombustible gases and nucleophilic compound that takes part in char layer formation by aminolysis of electrophilic substrates.Practical value. The optimum amine blowing agents for developing formulations of intumescent coatings with enhanced flame retardant properties have been established.
Мета. Дослідження впливу наноречовин, армувального волокна, неорганічних антипіренів і їх сумішей на побудову захисного коксового шару та вогнезахисну ефективність епоксидних покриттів складу поліфосфат амонію/меламін/пентаеритрит/діоксид титану/епоксидна смола. Методика. За модельну інтумесцентну систему обрано вогнезахисну поліфосфатну суміш, що містить епоксидну смолу бісфенолів A/F разом з поліамідоамінним затверджувачем. Методом термогравіметрії визначали вплив антипіренів та армувальних домішок на температурний режим розкладання інтумесцентного покриття. Коефіцієнт спучення та масу коксового залишку інтумесцентних композицій вивчали поетапно в інтервалі температур 200–800 оС. Вогневі випробування виконували у міні-печі в умовах стандартної пожежі згідно з методикою. Результати. Досліджено вплив нанографіту, наноглини, мінерального волокна та неорганічних антипіренів на формування та фізичні характеристики коксового шару інтумесцентної системи поліфосфат амонію/меламін/пентаеритрит/епоксидна смола в інтервалі температур 200–800 оС. Визначено, що вогнезахисна ефективність покриття знижується в ряду: оксинітрат графіту/органомодифікований монтморилоніт > органомодифікований монтморилоніт > борат цинку > оксинітрат графіту/мінеральне волокно. Розроблено рецептуру інтумесцентної системи на основі епоксидної смоли з антипіренами та армуючими домішками (органомодифікований монтморилоніт, оксинітрат графіту, борат цинку та мінеральне волокно), ефективність якої доведена вогневими випробуваннями. Наукова новизна. Вперше вивчено вплив оксинітрату графіту та його сумішей з наноречовинами та антипіренами на формування коксового шару та вогнезахисну ефективність епоксидного інтумесцентного покриття. Практична значимість. Встановлено оптимальний склад наноречовин, армувального волокна та неорганічних антипіренів для конструювання інтумесцентних епоксидних покриттів з підвищеними вогнезахисними властивостями.
Мета. Дослідження впливу етерів целюлози на реологічні властивості інтумесцентної вогнезахисної фарби та визначення структур загусників, які максимально удосконалюють експлуатаційні властивості лакофарбового матеріалу. Методика. За модельну інтумесцентну систему обрано вогнезахисне покриття реактивного типу, яке містить у своєму складі поліфосфат амонію, меламін, пентаеритрит, діоксид титану та полімер. У якості полімерної складової вивчали водні дисперсії співполімерів вінілацетату від різних виробників. Як целюлозні загусники використовували гідроксіетил- та гідроксипропіл етери целюлози, які визнані найбільш вдалими модифікаторами реології фарб на основі вінілацетатних полімерів. В’язкість вогнезахисних композицій вимірювали на віскозиметрі Брукфілда, розрахунок реологічних параметрів здійснювали за рівнянням Кассона. Результати. В дослідженні визначено вплив природи целюлозного загусника та полімеру на реологічні параметри, відповідальні за зберігання та нанесення лакофарбового матеріалу. Встановлено, що структура етеру целюлози має значення при регулюванні в'язкості досліджених інтумесцентних композицій. Найбільші значення в'язкості демонструє високомолекулярна гідроксіетилметил целюлоза (Bermocoll EM 7000 FQ). Гідроксипропіл метил целюлози є менш ефективними загусниками інтумесцентних фарб складу поліфосфат амонію/меламін/пентаеритрит/полімер. Природа полімерної складової, у свою чергу, майже не впливає на в'язкість досліджених композицій, що не містять загусника чи містять Bermocoll EM 7000 FQ. Для вивчених полімерних складових інтумесцентних композицій спостерігаються практично ідентичні реологічні профілі. Розрахунок реологічних параметрів – в'язкості при високих швидкостях зсуву, напруги зсуву, межі текучості із залученням рівняння Кассона дозволяє зробити висновок, що загущення вогнезахисних фарб інтумесцентного типу етерами целюлози є ефективним для запобігання седиментації при зберіганні та майже не впливає на збільшення товщини шару фарби, що можливо нанести за один прохід. Шляхом випробувань вогнезахисної ефективності покриттів в умовах міні-печі показано, що присутність етерів целюлози не зменшує вогнестійкість металевих пластин. Наукова новизна. Вперше визначено вплив структури целюлозних загусників на реологічні параметри вогнезахисної фарби інтумесцентного типу, відповідальні за зберігання та нанесення. Практична значимість. Отримані результати дозволяють визначити доцільні структури етерів целюлози, які можуть застосовуватися у промисловому виробництві інтумесцентних фарб.