The present research paper shows the use of Titanium oxide nanoparticle to enhance the yield of Solar still. Titanium Oxide and black die mixture used as a base paint and find out the performance of the solar still at 20% and 40% weight by weight in a combination of titanium oxide materials and a black die. To check the consequences of water depth on productivity yield, readings were taken at different depth of water like 10 mm, 15 mm, 20 mm. The reading of these experiments has compared with a conventional solar still (CSS) in the same location (Gandhinagar, India, 23.2156°N, 72.6369°E) at the same ambient conditions. The outcome of the experiment shows, at higher water depth productivity of solar still increases up to a certain limit. We find that in comparison with conventional solar still 11–18% and 20–23% increment in productivity with 20% and 40% mixture. Highlight
16 September 2020 in International Journal of Ambient Energy
This paper discusses the question of estimating a neural network induction motor speed. The neural network is trained in the relationship between stator currents and rotor speed. Rotor currents and speed are created using MATLAB from simulated model induction motor and from experimental real-time set-up using LABVIEW. With these two data sets, Induction motor is modeled using three neural network architectures, namely BPN, RBFN and Wavelet Neural Network, comparing the performance of each neural model in estimating speed. Results show the neural approach's ability to replace the speed sensor used in the closed loop speed control system to accurately estimate speed.
26 October 2020 in International Journal of Ambient Energy
Desalination with solar-powered air heating and packed bed humidification is designed and fabricated using locally available materials. The system with fined type dehumidifier is designed using the LMTD method. There are different solar desalination techniques such as solar still, solar air humidification dehumidification and solar water flash evaporation. Among these desalination techniques, solar air humidification dehumidification was already successfully used in very large-scale desalination but, not effectively tried for small-scale desalination. Desalination system with HDH was designed and fabricated during this research project for small-scale output. There are three main components of the system: Solar air heater, humidifier and dehumidifier. The packed bed was used in the design of humidifier for increasing the surface contact area of air with water. Psychrometric properties are recorded with the use of sensors DHT11 and ESP8266 micro-controller Wi-Fi board. The water temperatures are recorded with PT100 sensors and 8 channels data logger.
7 October 2020 in International Journal of Ambient Energy
Drinking water is considered one of the world's most important substances today. The amount of drinking water is also much lower. On the other hand, its use is immense both for the industry and for household duties. Solar still (SS) is known as a simple system for turning salty or brackish waters into fresh water with the application of solar energy. The temperature of the inner glass cover is an important factor in performance and condensers are used by researchers to reduce the condensation. This mini-review shows the work carried out by condenser researchers to improve the condensation rate and to improve the solar output. In the present mini-examination and various designs studied. Finally, the various possible future works for solar researchers have also been discussed.