Hot-stamped steel is currently the most widely used lightweight material in automobiles, and accurately predicting its failure risk during the simulation is a bottleneck problem in the automobile industry. In this study, the fracture failure behavior of the hot-stamped PHS2000 steel manufactured by Ben Gang Group (Benxi, China) is investigated by experiments and simulation. Static tension and high-speed tension tests are conducted to obtain the elastic-plastic stress-strain relations, and a Swift + Hockett–Sherby model is proposed to describe the hardening behavior under static and high-speed loads. Tests under five kinds of stress states, namely static shear, static tensile shear, notched static tension, center-hole static tension, and static punching, are conducted to obtain the ultimate fracture strains under different stress states for establishing a failure model. The finite element method (FEM) is used to inversely achieve the fracture parameters of the material, and the GISSMO model in LS-Dyna is adopted to describe the fracture characteristics of the material. A fracture card is further established for simulation analysis by combining fracture characteristics with high-speed tension curves and simultaneously loading size effect curves of meshes. Finally, the card is applied in the simulation of the three-point bending test. High-precision results of fracture simulation matching the experimental results are obtained. This research proves that the proposed fracture card is accurate and can be widely used in the simulation of fracture behaviors of the hot-stamped PHS2000 steel.
1 February 2020 in IOP Conference Series: Materials Science and Engineering
In order to study the influence factors of steel sheet surface waviness in cold rolling process, using coherence scanning interferometry, the surface waviness with different cold rolling processes had been investigated at room temperature, and without condensation according to relevant standard. The results show that the surface waviness of the typical steel was successfully evaluated, while the mill reduction rate, working roll cycle, and temper rolling elongation were found to be the most informative for surface waviness parameters Wa0.8 and Wsa1-5 It was found that the surface waviness parameters Wa0.8 and Wsa1-5 sharply increased with increasing rolling reduction rates in rolling process, and vice versa. Moreover, in the continuous annealing process, finish rolling temperature had almost no effect on the waviness. In temper rolling, the surface waviness parameters Wa0.8 and Wsa1-5 gradually increased with elongation and dropped with increasing working roll period. Ultimately, it was proved that the control measures to improve the surface waviness of steel plate in cold rolling process successfully improved the product surface quality.