Yannis Papananos

Prof. Dr. Yannis Papananos

orcid

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 February 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
VLVasileios Liakonis
Vasileios Liakonis
YPYannis Papananos
Yannis Papananos
FDFranz Dielacher
Franz Dielacher
MWMaciej Wojnowski
Maciej Wojnowski
WHWalter Hartner
Walter Hartner
In this paper, the performance, advantages and challenges of polymer microwave fibers (PMF) for sub-THz links are evaluated first. Then, a simple and elegant transceiver-integrated circuit (IC) and PMF wireless coupling scheme is presented. The proposed solution utilizes an advanced IC packaging technology to implement a Vivaldi antenna-in-package (AiP). The antenna is designed to provide lateral radiation and excellent directivity, so the proposed solution is very simple, compact, robust and cost-efficient: the IC readily connects to the PMF and the coupling is merely achieved by the packaged IC, without the need for any extra interface. The system operates at around 140 GHz, achieving a coupling loss of just 3.5 dB.

1 December 2004 in Analog Integrated Circuits and Signal Processing
Verified
Journal Article
Closed access
PDF file
NNNikos Naskas
Nikos Naskas
YPYannis Papananos
Yannis Papananos

1 November 2020 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
YPYannis Papananos
Yannis Papananos
KGKostas Galanopoulos
Kostas Galanopoulos
NANikolaos Alexiou
Nikolaos Alexiou
FDFranz Dielacher
Franz Dielacher

8 May 2026 in IEEE Access
Verified
Journal Article
Open access
VMVasileios Manouras
Vasileios Manouras
YPYannis Papananos
Yannis Papananos
FDFranz Dielacher
Franz Dielacher
This paper presents a fully integrated direct-conversion I/Q transmitter and receiver fabricated in a 130-nm SiGe BiCMOS process and experimentally validated through a short-range on-board link. At a carrier frequency of 120 GHz, the prototype has demonstrated data transmission up to 50 Gbps over a 50-mm microstrip trace on a standard multilayer printed circuit board. This is accomplished using 16-QAM modulation with a measured EVM of 14.7%. Although the PCB interconnect was intentionally implemented as a low-cost, non-optimized evaluation platform, the achieved link energy efficiency of 19.2 pJ/bit underscores the robustness of the proposed D-band transceiver and validates its suitability for high-speed intra-package and module-level communication at sub-THz frequencies.

29 June 2026 in Electronics
Verified
Journal Article
Open access
PDF file
TBThomas K Bountas
Thomas K Bountas
YSYorgos E Stratakos
Yorgos E Stratakos
Dimitra KaklamaniDimitra Kaklamani
Dimitra Kaklamani
YPYannis Papananos
Yannis Papananos
This paper presents the design and experimental validation of a passive I/Q downconversion subsystem for X-band applications, with emphasis on maritime radar operation. The proposed architecture combines passive RF and LO distribution networks with a single-balanced passive mixer, enabling accurate quadrature signal generation without relying on active correction mechanisms. The subsystem maintains controlled amplitude and phase balance across the operating band, directly supporting effective image suppression. Experimental results demonstrate image rejection ratios exceeding 30 dB. The mixer stage exhibits a conversion loss of approximately 6 dB and an input-referred 1-dB compression point of about 14 dBm. The incorporation of an optimized RF matching stub in the mixer improves the impedance conditions at the IF node, leading to enhanced linearity and enabling a favorable trade-off between conversion loss and 1-dB compression point. Performance further improves within the maritime radar allocation, where enhanced balance leads to increased image rejection. These results confirm that high-quality I/Q signal generation can be achieved using a passive and low-complexity architecture, providing a practical and reliable solution for broadband X-band receiver front-ends.

27 December 2025 in Microwave
Verified
Journal Article
Open access
PDF file
DGDimitrios Georgakopoulos
Dimitrios Georgakopoulos
VMVasileios Manouras
Vasileios Manouras
YPYannis Papananos
Yannis Papananos
This work presents a fully integrated, two-stage, deep class-AB power amplifier (PA) operating at a center frequency of 60 GHz. High efficiency and suppression of third-order intermodulation products are targeted, achieving improved linearity compared to reported state-of-the-art designs. A current combining architecture is also employed to enhance the output power capability. The PA is designed in a 22 nm FD-SOI CMOS technology and is optimized through a complete schematic-to-layout design flow. Post-layout simulations indicate that the PA achieves a peak power-added efficiency (PAE) of 28%, a saturated output power (Psat) of 20.2 dBm, and a maximum large-signal gain (Gmax) of 19.6 dB at 60 GHz, evaluated at an operating temperature of 60 °C. The design maintains high linearity across the targeted output power range, exhibiting effective suppression of third-order intermodulation distortion (IMD3), which enhances its suitability for spectrally efficient modulation schemes.