This paper presents a fully integrated direct-conversion I/Q transmitter and receiver fabricated in a 130-nm SiGe BiCMOS process and experimentally validated through a short-range on-board link. At a carrier frequency of 120 GHz, the prototype has demonstrated data transmission up to 50 Gbps over a 50-mm microstrip trace on a standard multilayer printed circuit board. This is accomplished using 16-QAM modulation with a measured EVM of 14.7%. Although the PCB interconnect was intentionally implemented as a low-cost, non-optimized evaluation platform, the achieved link energy efficiency of 19.2 pJ/bit underscores the robustness of the proposed D-band transceiver and validates its suitability for high-speed intra-package and module-level communication at sub-THz frequencies.
This work presents a fully integrated, two-stage, deep class-AB power amplifier (PA) operating at a center frequency of 60 GHz. High efficiency and suppression of third-order intermodulation products are targeted, achieving improved linearity compared to reported state-of-the-art designs. A current combining architecture is also employed to enhance the output power capability. The PA is designed in a 22 nm FD-SOI CMOS technology and is optimized through a complete schematic-to-layout design flow. Post-layout simulations indicate that the PA achieves a peak power-added efficiency (PAE) of 28%, a saturated output power () of 20.2 dBm, and a maximum large-signal gain () of 19.6 dB at 60 GHz, evaluated at an operating temperature of 60 °C. The design maintains high linearity across the targeted output power range, exhibiting effective suppression of third-order intermodulation distortion (IMD3), which enhances its suitability for spectrally efficient modulation schemes.
This paper deals with the design, analysis, and implementation of a Ka-band, single-stage, quasi-inverse class F power amplifier (PA). A detailed methodology for the evaluation of the active device’s output capacitance is described, enabling the designing of a second-harmonically tuned load and resulting in enhanced performance. A simplified model for the extraction of time-domain intrinsic voltage and current waveforms at the output of the main active core is introduced, enforcing the implementation process of the proposed quasi-inverse class F technique. The PA is fabricated in a 130 nm SiGe BiCMOS technology with and it is suitable for 5G applications. It achieves peak power-added efficiency (), saturation output power , and maximum large-signal power gain at the operating frequency of . The PA’s response is also tested under a modulated-signal excitation and simulation results are denoted in this paper. The chip size is including all pads.