Air quality in Europe continues to remain poor in many areas, with regulation limits often exceeded by many countries. The EU Life-IP PREPAIR Project, involving administrations and environmental protection agencies of eight regions and three municipalities in Northern Italy and Slovenia, was designed to support the implementation of the regional air quality plans in the Po Valley, one of the most critical areas in Europe in terms of pollution levels. In this study, four air quality modelling systems, based on three chemical transport models (CHIMERE, FARM and CAMx) were applied over the Po Valley to assess the sensitivity of PM2.5 concentrations to NOx and NH3 emission reductions. These two precursors were reduced (individually and simultaneously) from 25% up to 75% for a total of 10 scenarios, aimed at identifying the most efficient emission reduction strategies and to assess the non-linear response of PM2.5 concentrations to precursor changes. The multi-model analysis shows that reductions across multiple emission sectors are necessary to achieve optimal results. In addition, the analysis of non-linearities revealed that during the cold season, the efficiency of PM2.5 abatement tends to increase by increasing the emission reductions, while during summertime, the same efficiency remains almost constant, or slightly decreases towards higher reduction strengths. Since the concentrations of PM2.5 are greater in winter than in summer, it is reasonable to infer that significant emission reductions should be planned to maximise reduction effectiveness.
This paper describes an innovative method that recursively applies the machine learning Random Forest to an assumed homogeneous aerographic domain around measurement sites to predict concentrations and emissions of ammonia, an atmospheric pollutant that causes acidification and eutrophication of soil and water and contributes to secondary PM2.5. The methodology was implemented to understand the effects of weather and emission changes on atmospheric ammonia concentrations. The model was trained and tested by hourly measurements of ammonia concentrations and atmospheric turbulence parameters, starting from a constant emission scenario. The initial values of emissions were calculated based on a bottom-up emission inventory detailed at the municipal level and considering a circular area of about 4 km radius centered on measurement sites. By comparing predicted and measured concentrations for each iteration, the emissions were modified, the model’s training and testing were repeated, and the model converged to a very high performance in predicting ammonia concentrations and establishing hourly time-varying emission profiles. The ammonia concentration predictions were extremely accurate and reliable compared to the measured values. The relationship between NH3 concentrations and the calculated emissions rates is compatible with physical atmospheric turbulence parameters. The site-specific emissions profiles, estimated by the proposed methodology, clearly show a nonlinear relation with measured concentrations and allow the identification of the effect of atmospheric turbulence on pollutant accumulation. The proposed methodology is suitable for validating and confirming emission time series and defining highly accurate emission profiles for the improvement of the performances of chemical and transport models (CTMs) in combination with in situ measurements and/or optical depth from satellite observation.
This paper presents a novel machine learning methodology able to extend the results of detailed local emission inventories to larger domains where emission estimates are not available. The first part of this work consists in the development of an emission inventory of elemental carbon (EC), black carbon (BC), organic carbon (OC), and levoglucosan (LG) obtained from the detailed emission estimates available from the Project LIFE PREPAIR for the Po Basin in north Italy. The emissions of these chemical species in combination with particulate primary emissions and gaseous precursors are very important information in source apportionment and in the impact assessment of the different emission sources in air quality. To gain a better understanding of the origins of atmospheric pollution, it is possible to combine measurements with emission estimates for the particulate matter fractions known as EC, BC, OC, and LG. To identify the sources of emissions, it is usual practice to use the ratio of the measured EC, OC, TC (Total Carbon), and LG. The PREPAIR emission estimates and these new calculations are then used to train the Random Forest (RF) algorithm, considering a large array of local variables, such as taxes, the characteristics of urbanization and dwellings, the number of employees detailed for economic activities, occupation levels and land cover. The outcome of the comparison of the predictions of the machine learning implemented model (ML) with the estimates obtained for the same areas by two independent methods, local disaggregation of the national emission inventory and Copernicus Air Modelling Service (CAMS) emissions estimates, is extremely encouraging and confirms it also as a promising approach in terms of effort saving. The implemented modelling approach identifies the most important variables affecting the spatialization of different pollutants in agreement with the main emission source characteristics and is suitable for harmonization of the results of different local emission inventories with national emission reporting.
Air quality in the Po Valley (Northern Italy), one of Europe’s most polluted regions, remains a major concern due to its unfavorable orographic setting and intense anthropogenic emissions. Climate change may further hinder progress by modifying meteorological conditions that regulate pollutant dispersion and chemistry. This study applies a modeling framework combining regional climate simulations and chemical transport models to assess the climate penalty, i.e., the adverse impact of climate-driven meteorology on air quality independent of emissions. Three scenarios were analyzed: Baseline Reference Scenario (SRB) (2011–2015), Near-Future Medium Scenario (NF) (2028–2032), and Mid-Future Medium Scenario (2048–2052), with emissions held constant. A mitigation scenario (SC_MF_2050) under the Current Legislation was also tested to accomplish the new EU Ambient Air Quality Directive. Results show that PM10 and NO2 increase under future climates, mainly due to reduced wind speed and precipitation, enhancing pollutant accumulation. Multivariate analyses confirm the strong association between stagnant conditions and higher concentrations. Even with projected emission reductions, compliance with stricter EU targets may not be achieved everywhere. Climate penalty zones, especially in lowland and transport corridors, underscore the need to integrate climate resilience into air quality planning and adopt adaptive strategies for long-term effectiveness.
Ammonia is an atmospheric pollutant, predominantly emitted from agriculture, leading acidification and eutrophication of soil and water and contributing to secondary PM2.5. The implementation of accurate emission inventories with high spatial and time resolution plays a fundamental role in the development of air modelling simulation and in the impact assessment of actions for air quality improvement. The development and release of new algorithms and the increase of data availability are supporting the implementation of machine learning approaches in environmental and air quality data analysis. In this paper we present a methodology developed by the application of the Random Forest algorithm to bottom-up local emission inventories of ammonia to validate annual time series of ammonia emissions and calculate high resolution temporal profiles. The model has been trained and tested by the hourly measurements of ammonia concentrations and atmospheric turbulence parameters starting from a constant emission scenario. The initial values of emissions are calculated based on a bottom-up emission inventory detailed at the municipal basis and considering a circular area of about 4 km radius centered on measurement sites. By comparing predicted and measured concentrations, the emissions are modified, the model's training and testing are repeated, and the model converges to a very high performance in predicting ammonia concentrations and establishing an hourly time changing emission profile. The site-specific emissions profiles, estimated by the proposed methodology, clearly show a nonlinear relation with measured concentrations and allow to identify the effect of atmospheric turbulence on pollutant accumulation. The estimated time series well confirm the available data of the emission inventories and the monthly emission profiles have been compared with estimated data from satellite.