Uncompensated friction forces compromise the positioning and tracking accuracy of motion systems. A unique tracking error known as quadrant glitch is the result of complex nonlinear friction behavior at motion reversal or near-zero velocity. Linear-feedback control strategies such as PID, cascade P/PI, or state-feedback control have to be extended with model- and nonmodel-based friction-compensation strategies to acquire sufficiently high path and tracking accuracy. This paper analyzes and validates experimentally three different friction-compensation strategies for a linear motor-based xy feed drive of a high-speed milling machine: (1) friction-model-based feedforward; (2) an inverse-model-based disturbance observer; and (3) the combination of both techniques. The friction models considered are as follows: a simple static-friction model and the recently developed generalized Maxwell-slip (GMS) model. GMS friction-model-based feedforward combined with disturbance observer almost completely eliminates the radial tracking error and quadrant glitches.
Accurate tracking is essential for machine tools. Both friction forces and cutting forces contribute to positioning and tracking errors. This paper considers contour tracking errors caused by friction forces only. The complex non-linear behaviour of friction at motion reversal causes a unique tracking error known as quadrant glitch. Compensation of quadrant glitches is desired to minimize surface contour error that is visible in circular tracking test. This paper analyzed, simulated and experimentally validated three different friction compensation strategies on a machine tool linear drive: (i) feedforward based on two friction models proposed in the literature, (ii) an inverse- model-based disturbance observer, and (iii) the combination of friction model feedforward and disturbance observer. The considered friction models are a simple static friction model and the recently developed Generalized Maxwell-slip friction model. The combination of feedforward based on the Generalized Maxwell-slip friction model and the disturbance observer yield the smallest tracking error and glitches.
22 May 2017 in International Journal of Control, Automation, and Systems
This paper presents contouring error analysis using various classical feedforward controllers. A circular motion is performed using an XY positioning stage with specified amplitude and velocities. This study applied single Static friction model, Generalized Maxwell Slip (GMS) model and combination of both models together with feedforward Proportional-Integral-Derivative (PID) controller. Contour error in term of quadrant glitch is measured by respective angle in each quadrant of circular motion. Due to stick slip motion during velocity reversal generate glitches near zero velocity. Root-mean-square error (RMSE) is calculated based on radial error of circular motion to show variance of errors towards average. The results are experimentally shown that glitches have higher reduction in lower velocity by comparing between applied with and without friction feedforward controller. Better reduction in contour errors improves precision of machine tools and hence increases productivity
This paper focuses on friction identification and numerical validation on ball-screw driven XY milling table. Two friction models namely; static friction model and Generalized Maxwell-slip (GMS) model are identified and validated numerically. Static friction model is identified by measuring the control command signals of various constant velocities while friction-position behavior during sliding and pre-sliding regimes is determined to identify GMS model. Parameters of static friction model are estimated using heuristic approach while application of piecewise linear functions and theory of superposition in virgin curve are used in approximating the parameters of GMS model. Based on obtained parameters, the models are generated in simulation using MATLAB/Simulink to verify the friction models and glitches formed during motion of low velocity. Simulation results showed that GMS model produced clearer and larger glitches compared to static friction model during low velocity motion. GMS model is capable of characterizing the friction behavior during pre-sliding.