In the process of the double-layer gas-assisted extrusion of plastic micro-tubes, the external size and surface quality of the micro-tubes are greatly affected by the size of the assisting gas inlet slit inside the mold. Therefore, in this experiment, a two-phase flow model was established based on a compressible gas and a non-compressible melt. The Polyflow finite element solution software module was used to solve the velocity field, temperature field, pressure field, and section size of the melt under the condition of double-layer gas-assisted extrusion in a mold under different gas inlet slit widths. The results show that, with an increase in the width of the gas inlet slit, the melt outlet velocity increases, the surface temperature increases, wall thickness shrinkage increases, and interior diameter expansion increases. In the process of gas-assisted extrusion, the thickness of the air cushion is affected by adjusting the size of the gas inlet slit, and, hence, changes the shape and size of the plastic micro-tubes.

During the gas-assisted extrusion process of plastic tubes embedded with antibacterial particles, the particles tend to agglomerate. The dispersion effect of these agglomerates using the nozzle-pressure-difference method is significantly influenced by the gas flow state. Therefore, this study establishes the nozzle dispersion model. The gas flow state near the nozzle is simulated and analyzed by using Ansys Fluent software. Gas-assisted extrusion experiments are conducted with different nozzle inlet pressures, and the size distribution of antibacterial particles is observed by using electron microscopy. The simulation results indicate that increasing the nozzle inlet pressure enhances the dispersion effect and expands the effective dispersion area. The experimental results demonstrate that using the nozzle disperses the agglomerates into particles with a diameter of approximately 100 nm. Furthermore, the nanoparticles diameter size decreases with the increase of the inlet pressure, validating the accuracy of the numerical analysis results.