The design of flexible floating anticollision systems (FFAS) against collision by uncontrolled vessels is based on quasi-static considerations, in which the maximum loading is taken to occur when the vessel is brought to a standstill and its kinetic energy is completely transferred to the strain and frictional energy of FFAS. The dynamic loading during the collision process due to system response characteristics of the FFAS is typically ignored. In the present study, the authors demonstrated through an experimental investigation that it is critical to consider both quasi-static and dynamic loadings to design against possible failures of the system. The experimental investigation was performed as a case study for a FFAS to protect a chemical wharf at Zhangzhou Port, China. The system consisted of a row of floating buoys connecting and mooring with steel chains. Extensive physical modeling tests were performed to quantify the motion of the collided buoy and the tensions of selected block and mooring chains when the FFAS was struck by a 5,000-DWT (deadweight tonnage) vessel model with different initial velocities. The results showed that the transient impact force on the system had multiple dynamic peaks during the collision process. Most importantly, the maximum loading on the FFAS (and the reaction impact force on the vessel in the opposite direction) occurred at a dynamic peak prior to when the vessel was halted to a standstill, and the magnitude was larger than the maximum quasi-static loading based on energy transfer principle alone. Thus, the case study highlighted the importance of including the dynamic loading and responses into the design considerations of FFAS.
1 February 2016 in SCIENTIA SINICA Physica, Mechanica & Astronomica
The submerged floating tunnel (SFT) is a novel form of transportation infrastructure for crossing deeper and wider seas. One of the primary challenges in designing SFTs is understanding their hydrodynamic response to complex environmental loads. In order to investigate the two-degree-of-freedom (2-DOF) flow-induced vibration (FIV) response of SFTs under current, a two-dimensional (2D) numerical model was developed using the Reynolds-averaged Navier–Stokes (RANS) method combined with the fourth-order Runge–Kutta method. The numerical results were validated by comparing them with the existing literature. The study then addressed the effects of coupled vibration and structural parameters, i.e., the mass ratio and natural frequency ratio, on the response and wake pattern of SFTs, numerically. The results indicated that coupled vibration had a significant impact on the SFT response at reduced velocities of Urwx ≥ 4.4. A decrease in mass ratio (m* < 1) notably amplified the 2-DOF vibration amplitudes of SFTs at Urwx ≥ 4.4, particularly for in-line vibration. Similarly, a decrease in natural frequency ratio (Rf < 1) significantly suppressed the in-line vibration of SFTs at Urwx ≥ 2.5. Therefore, for the design of SFTs, careful consideration should be given to the effect of mass ratio and natural frequency ratio on in-line vibration.
Existing numerical models for direct simulations of stochastically directional waves are limited by their computational burden, and only a few of them can be applied to modeling directional waves on account of nonlinear evolutions on large time scales. In response to these drawbacks, this paper proposes a modified rectangular numerical wave tank based on the high-order spectral (HOS) method. Three main arrangements are responsible for the model improvement. Firstly, the relaxation technique is applied on the four sides of the tank for generating and attenuating waves, with an enhancement in the total computational efforts required of less than 5% being achieved. Secondly, for this paper, the HOS method for solving the nonlinear evolution of waves was modified to a GPU-speedup version for the first time, and the speedup increases dramatically (up to 16-fold) when the grid number is O(106). Thirdly, the higher-order Runge–Kutta method with order 8 is adopted for the purpose of suppressing cumulative temporal errors. Furthermore, several numerical results are presented for the validation of the model. With our modified numerical wave tank, the nonlinear evolutions of random directional waves can be efficiently studied over a large time and space scale.