This review explores the development of microchip-based nanocalorimeters for small scale and high rate thermal measurements. Nanocalorimetry is a growing field of importance given the ability to investigate the thermal behavior of thin films and nanomaterials. It can reveal how thermal properties scale with size and provide direct measurements of high rate and multistep reactions, nucleation in complex environments, and surface effects, even on samples below a monolayer.
6 February 2015 in Journal of Microelectromechanical Systems
We evaluate the microstructural and electrical stability of Pt thin films with Ti or Ta as the adhesion layer after furnace annealing and rapid thermal annealing up to 750°C in three different environments. Test devices were made with 100 nm of Pt with a 10-nm adhesion layer. After annealing, the resistance anomalously increased for samples annealed in ultrahigh purity N 2 (UHP, 99.999%), while the resistance decreased, as expected, for samples annealed in 99.95% N 2 or air. The Ta/Pt film stack shows better microstructural and electrical stability compared with Ti/Pt. X-ray photoelectron spectroscopy (XPS) data indicate that diffusion of the Ti and Ta adhesion layers through the Pt film occurs in samples annealed in UHP N 2 , which is responsible for the remarkable increase of resistance. For samples annealed in air, the oxidation of Ti/Ta suppresses the diffusion process and expected grain growth occurs in the Pt, thus decreasing the resistance. Furthermore, XPS elemental mapping and atomic force microscope imaging shed light on void formation/dewetting seen under certain conditions.
13 July 2022 in Journal of the American Chemical Society
Numerous phosphorus-rich metal phosphides containing both P-P bonds and metal-P bonds are known from the solid-state chemistry literature. A method to grow these materials in thin-film form would be desirable, as thin films are required in many applications and they are an ideal platform for high-throughput studies. In addition, the high density and smooth surfaces achievable in thin films are a significant advantage for characterization of transport and optical properties. Despite these benefits, there is hardly any published work on even the simplest binary phosphorus-rich phosphide films. Here, we demonstrate growth of single-phase CuP2 films by a two-step process involving reactive sputtering of amorphous CuP2+x and rapid annealing in an inert atmosphere. At the crystallization temperature, CuP2 is thermodynamically unstable with respect to Cu3P and P-4. However, CuP2 can be stabilized if the amorphous precursors are mixed on the atomic scale and are sufficiently close to the desired composition (neither too P poor nor too P rich). Fast formation of polycrystalline CuP2, combined with a short annealing time, makes it possible to bypass the diffusion processes responsible for decomposition. We find that thin-film CuP2 is a 1.5 eV band gap semiconductor with interesting properties, such as a high optical absorption coefficient (above 10(5) cm(-1)), low thermal conductivity (1.1 W/(K m)), and composition-insensitive electrical conductivity (around 1 S/cm). We anticipate that our processing route can be extended to other phosphorus-rich phosphides that are still awaiting thin-film synthesis and will lead to a more complete understanding of these materials and of their potential applications.
16 December 2019 in Journal of Research of the National Institute of Standards and Technology
We report here on the design, fabrication, and calibration of nanocalorimeter sensors used in the National Institute of Standards and Technology (NIST) Nanocalorimetry Measurements Project. These small-scale thermal analysis instruments are produced using silicon microfabrication approaches. A single platinum line serves as both the heater and temperature sensor, and it is made from a 500 μm wide, 100 nm thick platinum trace, suspended on a 100 nm thick silicon nitride membrane for thermal isolation. Supplemental materials to this article (available online) include drawing files and LabVIEW code used in the fabrication and calibration process.
11 March 2019 in Journal of Thermal Analysis and Calorimetry