Abrasive waterjet (AWJ) fracturing has become an accepted horizontal multistage stimulation technique due to its flexibility and high efficiency of extensive fracture placement. The downhole tool failure of AWJ fracturing becomes an issue in the massive hydraulic fracturing because of high velocity and proppant erosion. This paper proposed a 3D computational fluid dynamics (CFD)-based erosion model by considering high-velocity waterjet impact, proppant shear erosion, and specific inner structure of hydra-jet tool body. The discrete phase approach was used to track the proppant transport and its concentration distribution. Field observation provides strong evidence of erosion patterns and mechanisms obtained from CFD simulation. The results show that the erosion rate has a space dependence in the inner wall of the tool body. The severe erosion areas are primarily located at the entries of the nozzle. Evident erosion patterns are found including a ‘Rabbit’s ear’ erosion at the upper-layer nozzles and a half bottom loop erosion at the lower-layer nozzles. Erosion mechanisms attribute to high flow velocity at the entry of nozzles and the inertia force of proppant. Sensitivity analysis demonstrates that the pumping rate is a primary factor contributing to erosion intensity.
Properties of shale in an acid environment are important when acid or CO2 is injected into geologic formations as a working fluid for enhanced oil and gas recovery, hydraulic fracturing and reduced fracture initiation pressure. It has previously been shown that acid fluids can enhance the formation conductivity and decrease the hardness of shale. However, less is known about the effect of dilute acid on the adhesion properties of shale. In the study, shale samples are characterized in detail with advanced analysis. Adhesion properties of shale via dilute acid treatment were revealed by atomic force microscopy (AFM) for the first time. Results indicate that acid treatment can greatly enhance adhesion forces of the shale surface. After acid treatment, the average adhesion forces show a platform-like growth with an increase in loading force. Through analysis of results from AFM, scanning electron microscopy, and X-ray diffraction, we affirm that the enhanced adhesion forces are mainly from increased specific surface area and reduced elastic modulus. The results presented in this work help understand the adhesion properties of shale oil/gas present in an acidic environment, which have great significance in unconventional resources development.
Hydraulic fracturing is a crucial technique for the extraction of geothermal energy from hot dry rock reservoirs. However, the development of such reservoirs faces significant challenges due to the high in-situ stress and strong elastic-plastic behavior of these rocks, which often result in simplified fracture geometries and subsequent low heat extraction efficiency. To address this issue, a novel reservoir treatment method based on thermal expansion and contraction principles is proposed. By applying alternating heating-cooling treatments to the reservoir, cyclic thermal stress is generated within the rock to enhance the complexity of post-fracturing fracture networks. To investigate the resultant hydraulic fracture propagation under alternate-temperature loading, a custom-developed thick-walled cylinder expansion fracturing device was employed to study the fracture propagation mechanisms in hot dry rock samples under cyclic thermal loading. The fracture network complexity was characterized by the fractal dimension method. Experimental results demonstrated that alternate thermal load cycling significantly enhances the fracture network complexity compared to conventional single-phase heat treatment. The maximum improvement in fractal dimension (3.86% increase) was observed at 500 ◦C. Under alternating temperature loads, the upper surface fractures predominantly exhibited bilateral symmetric structures. At 600 ◦C, a substantial increase in branched fractures and rock debris near boreholes occurred, indicating that alternating temperature loads significantly enhance the complexity of engineered fracture networks in hot dry rock. These findings suggest that incorporating thermal cycling into hydraulic fracturing processes can significantly improve the fracture network complexity, thereby enhancing the efficiency of heat extraction from hot dry rock reservoirs. Document Type: Original article Cited as: Wang, D., Dong, Y., Wei, C., Zhang, Q., Sheng, M., Yu, B. Expansion-induced fracture propagation in deep geothermal reservoirs under alternate-temperature loading. Advances in Geo-Energy Research, 2025, 15(3): 261-272. https://doi.org/10.46690/ager.2025.03.08