Hydraulic fracturing is a crucial technique for the extraction of geothermal energy from hot dry rock reservoirs. However, the development of such reservoirs faces significant challenges due to the high in-situ stress and strong elastic-plastic behavior of these rocks, which often result in simplified fracture geometries and subsequent low heat extraction efficiency. To address this issue, a novel reservoir treatment method based on thermal expansion and contraction principles is proposed. By applying alternating heating-cooling treatments to the reservoir, cyclic thermal stress is generated within the rock to enhance the complexity of post-fracturing fracture networks. To investigate the resultant hydraulic fracture propagation under alternate-temperature loading, a custom-developed thick-walled cylinder expansion fracturing device was employed to study the fracture propagation mechanisms in hot dry rock samples under cyclic thermal loading. The fracture network complexity was characterized by the fractal dimension method. Experimental results demonstrated that alternate thermal load cycling significantly enhances the fracture network complexity compared to conventional single-phase heat treatment. The maximum improvement in fractal dimension (3.86% increase) was observed at 500 ◦C. Under alternating temperature loads, the upper surface fractures predominantly exhibited bilateral symmetric structures. At 600 ◦C, a substantial increase in branched fractures and rock debris near boreholes occurred, indicating that alternating temperature loads significantly enhance the complexity of engineered fracture networks in hot dry rock. These findings suggest that incorporating thermal cycling into hydraulic fracturing processes can significantly improve the fracture network complexity, thereby enhancing the efficiency of heat extraction from hot dry rock reservoirs. Document Type: Original article Cited as: Wang, D., Dong, Y., Wei, C., Zhang, Q., Sheng, M., Yu, B. Expansion-induced fracture propagation in deep geothermal reservoirs under alternate-temperature loading. Advances in Geo-Energy Research, 2025, 15(3): 261-272. https://doi.org/10.46690/ager.2025.03.08
Field tests indicate that temporary well shut-ins may enhance oil recovery from a shale reservoir; however, there is currently no systematic research to specifically guide such detailed operations in the field, especially for the design of the shut-in scheme and multiple rounds of shut-ins. In this study, the applicability of well shut-in operations for shale oil reservoirs is studied, and a numerical model is built using the finite element method. In order to simulate the production in a shale oil reservoir, two separate modules (i.e., Darcy’s law and phase transport) were two-way coupled together. The established model was validated by comparing its results with the analytical Buckley–Leverett equation. In this paper, the geological background and parameters of a shale oil reservoir in Chang-7 Member (Chenghao, China) were used for the analyses. The simulation results show that temporary well shut-in during production can significantly affect well performance. Implementing well shut-in could decrease the initial oil rate while decreasing the oil decline rate, which is conducive to long-term production. After continuous production for 1000 days, the oil rate with 120 days shut-in was 9.85% larger than the case with no shut-in. Besides, an optimal shut-in time has been identified as 60 days under our modeling conditions. In addition, the potential of several rounds of well shut-in operations was also tested in this study; it is recommended that one or two rounds of shut-ins be performed during development. When two rounds of shut-ins are implemented, it is recommended that the second round shut-in be performed after 300 days of production. In summary, this study reveals the feasibility of temporary well shut-in operations in the development of a shale oil reservoir and provides quantitative guidance to optimize these development scenarios.