We experimentally study the nonlinear dynamics of a femtosecond ytterbium doped mode-locked fiber laser. With the laser operating in the pulsed regime a route to chaos is presented, starting from stable mode-locking, period two, period four, chaos and period three regimes. Return maps and bifurcation diagrams were extracted from time series for each regime. The analysis of the time series with the laser operating in the quasi mode-locked regime presents deterministic chaos described by an unidimensional Rössler map. A positive Lyapunov exponent λ = 0.14 confirms the deterministic chaos of the system. We suggest an explanation about the observed map by relating gain saturation and intra-cavity loss.
We investigate the replica symmetry breaking (RSB) phenomenon in random lasers (RLs) through Monte Carlo simulations employing photonic random walkers that diffuse and get randomly scattered in the active medium. The walkers interact not only with the population of excited atoms, but also among themselves, in a mean-field-type approach based on the Langevin equation for the stochastic dynamics of RL modes. We obtain the proper profile of the distribution of the Parisi overlap parameter in the RSB glassy phase, with two pronounced side maxima at above the RL threshold, in contrast with some recent numerical studies. Remarkably, when the interactions among photonic walkers are not included, a replica-symmetric profile with a single maximum of at is found for any excitation energy. We further study the Gaussian and Lévy emission regimes and statistical correlations of intensity fluctuations in distinct modes of the same spectrum, using a Pearson correlation coefficient recently applied to RLs. Our findings are consistent with experimental results for the intensity statistics and distributions in RL materials.
This study applied the finite element method (FEM) and the moiré strip projection method to evaluate the biomechanical behavior of healthy and endodontic-treated premolar teeth. The finite element method and the moiré strip projection method were applied to evaluate the influence of restored materials in association with cervical lesions and were considered as strain estimates for a tooth sample with 21 units, under loads of 25, 50, 75, and 100 N, frontal and oblique applied. The focused cases were: tooth H healthy; tooth A-MOD amalgam; tooth AL-MOD amalgam + lesion; tooth ALR-MOD amalgam + injury restored; tooth R-MOD resin; tooth RL-MOD resin + lesion; tooth RLR-MOD resin + injury restored. The results obtained by FEM simulation can be considered perfectly validated by the results presented by the experimental moiré projection analysis, demonstrating that the FEM numerical analysis can be used to evaluate the biomechanical behavior of healthy and endodontically treated teeth. Developing an alternative protocol to generate FEM three-dimensional models will lead to a ready and inexpensive tool since there is no need for costly equipment for tooth extraction prognosis.