To avoid hydrogen flaking in rail production, it is of crucial importance to understand the differences in hydrogen diffusion and trapping between different production steps. Therefore, as-cast unfinished material was compared with two finished rails, hot-rolled and head-hardened, using electron backscattered diffraction (EBSD), electrochemical permeation, and thermal desorption spectroscopy (TDS). A significant increase in dislocation density was in the head-hardened rail compared with the other material states. This leads to an effective hydrogen diffusion coefficient of 5.8 × 10−7 cm2/s which is lower by a factor of four than the diffusion coefficients examined in the other states. Thermal desorption spectroscopy analyses show a clear difference between unfinished and finished rail materials. While a peak in activation energy between 32 and 38 kJ/mol is present at all states, only as-cast unfinished material shows a second peak with an activation energy of 47 kJ/mol, which is related to microvoids. The results show that in the investigated material, the effect of increasing dislocation density has a stronger influence on the effective diffusion coefficient than the presence of a second active trapping site.
Comprehensive studies of hydrogen embrittlement in high-strength austenitic alloys under cryogenic conditions are scarce, leaving the combined effect of hydrogen charging and extreme temperatures largely unexplored. Given the demands of cryogenic applications such as hydrogen storage and transport, understanding material behavior under these conditions is crucial. Here, we present the first systematic study of hydrogen’s effect at liquid helium temperature (4.2 K) on the mechanical properties of precipitation hardened austenitic alloys, specifically the nickel-based Alloy 718 and austenitic stainless steel A286. Both materials were subjected to pressurized hydrogen charging at 473 K followed by slow strain rate tensile testing at room temperature and at 4.2 K. Hydrogen charging caused significant ductility loss at room temperature in both alloys. In contrast, testing at 4.2 K resulted in increased strength and no evidence of hydrogen embrittlement. Notably, materials pre-charged with hydrogen and tested at 4.2 K exhibited higher stress drop amplitudes and increased strain accumulation during serration events, suggesting persistent hydrogen–dislocation interactions and possible enhanced dislocation pinning by obstacles such as Lomer–Cottrell locks. These results indicate that while hydrogen influences plasticity mechanisms at cryogenic temperatures, embrittlement is suppressed, providing new insight into the safe development of austenitic alloys in cryogenic hydrogen environments.