Laser triangulation systems (LTS) are one of the most popular non-contact inspection techniques. These systems are widely used in reverse engineering tasks as they allow for a fast acquisition of thousands of points that represent the geometry of the part in a virtual 3D model. The accuracy and repeatability of these systems are lower than the traditional contact inspection techniques, as they depend on the surface properties, the illumination conditions and the LTS configuration. Present work deals with the influence of surface material on the quality of the virtual model. The objective is to evaluate the behaviour of different materials and their suitability for being digitized.

A method for solving the problem of bend sequencing in sheet metal manufacturing is presented. The algorithm developed divides the part into basic shapes (channels and spirals) and determines the partial sequences associated with them. The complete bending sequences associated with the complete part were obtained from the combination of these partial sequences. To make this combination possible, several strategies were defined to reduce the number of solutions and, therefore, the searching time. All sequences (partial and complete) were checked considering possible part-tool collisions and tolerance constraints. The last stage was to order the sequences by taking into account the total process time. To attain the required process time accuracy, a robot was used for the handling operations. Finally, the sequence associated with the lower process time was selected as the optimal solution.

Accessibility analysis represents one of the most critical tasks in inspection planning. This analysis determines those probe orientations that can touch an inspection point without collision. This paper presents a methodology based on part discretization and the application of space partitioning techniques (kd-tree) in order to reduce the number of intersection tests between probe and part. A STL model has been used for discretizing the inspection part in a set of triangles, which permits the application of the developed system to any type of part, regardless of its shape and its complexity. Likewise, a recursive ray traversal algorithm has been used in order to speed up the traversal of the kd-tree hierarchical structure and to calculate exclusively the intersection of each probe orientation with those part triangles that can potentially interfere with it. In a further step of the analysis, the real geometry of the probe has been considered. Hence, a simplified model has been developed for each probe component (column, head, touch probe, stylus and tip) using different basic geometrical shapes. Finally, collision-free probe orientations are clustered for minimizing the orientation changes during the inspection process. Furthermore, the applied algorithm allows for determining different valid combinations of clusters. The developed system was applied to two example parts in order to prove that this methodology is adequate for the solution of real cases.

Conoscopic holography (CH) is a non-contact interferometric technique used for surface digitization which presents several advantages over other optical techniques such as laser triangulation. Among others, the ability for the reconstruction of high-sloped surfaces stands out, and so does its lower dependence on surface optical properties. Nevertheless, similarly to other optical systems, adjustment of CH sensors requires an adequate selection of configuration parameters for ensuring a high quality surface digitizing. This should be done on a surface located as close as possible to the stand-off distance by tuning frequency (F) and power (P) until the quality indicators Signal-to-Noise Ratio (SNR) and signal envelope (Total) meet proper values. However, not all the points of an actual surface are located at the stand-off distance, but they could be located throughout the whole working range (WR). Thus, the quality of a digitized surface may not be uniform. The present work analyses how the quality of a reconstructed surface is affected by its relative position within the WR under different combinations of the parameters F and P. Experiments have been conducted on AISI 316 wire EDM machined flat surfaces. The number of high-quality points digitized as well as distance measurements between different surfaces throughout the WR allowed for comparing the metrological behaviour of the CH sensor with respect to a touch probe (TP) on a CMM.