This study aimed to investigate the potential reserves of potable water in Islamabad, Pakistan, considering the alarming depletion of water resources. A detailed vertical electrical sounding (VES) survey was conducted in two main localities: Bara Kahu (Area 1) and Aabpara to G-13 (Area 2), based on accessibility, time, and budget constraints. A total of 23 VES measurements were performed, with 13 in Area 1 and 10 in Area 2, reaching a maximum depth of 500 m. Geologs and pseudosections were generated to assess lithological variations, aquifer conditions, and resistivity trends with depth. Statistical distribution of resistivity (SDR), hydraulic parameters, true resistivity, macroanisotropy, aquifer depth and thickness, and linear regression (R²) curves were calculated for both areas, providing insights into the aquifer conditions. The results revealed that the study areas predominantly consisted of sandy lithology as the aquifer horizon, encompassing sandstone, sandy clay, and clayey sand formations. Area 2 exhibited a higher presence of clayey horizons, and aquifers were generally deeper compared to Area 1. The aquifer thickness ranged from 10 m to 200 m, with shallow depths ranging from 10 m to 60 m and deeper aquifers exceeding 200 m. Aquifers in Area 1 were mostly semi-confined, while those in Area 2 were predominantly unconfined and susceptible to recharge and potential contamination. The northwest–southeast side of Area 1 exhibited the highest probability for ground resource estimation, while in Area 2, the northeast–southwest side displayed a dominant probability. The study identified a probable shear zone in Area 2, indicating lithological differences between the northeast and southwest sides with a reverse sequence. Based on the findings, it is recommended that the shallow aquifers in Area 1 be considered the best potential reservoir for water supply. In contrast, deeper drilling is advised in Area 2 to ensure a long-lasting, high-quality water supply. These results provide valuable information for water resource management and facilitate sustainable water supply planning and decision making in Islamabad, Pakistan.

Especially in recent years, the study of landslide phenomena is considered as very important because of the effects of climate change. The aim of this paper is to examine the stability of the slope located in Miacher Nagar village along the Hunza River (HR), using the Limit Equilibrium Method (LEM). The Miacher slope rises to a height of 900 m from the foot of the Hunza River and has a base angle of 50 degrees. Meta-sediments and quaternary recent glaciated deposits make up the majority of the slope’s composition. The slope movement of Miacher was first triggered in 1995, and was further triggered in 2010 and 2013. The slope was geologically, geomorphologically, geotechnically and geochemically investigated as well as modeled by Slope/w to determine the safety factor. Soil samples were analyzed for their geotechnical, geological and geomorphological properties. The Limit Equilibrium Method (LEM) was employed in this study to analyze the Factor of Safety (FOS) of the slope, based on assumptions of the Morgenstern and Price, Ordinary, Janbu and Bishop Methods, using the Slope/w software. Various factors, including pore water pressure, unit weight, cohesion, angle of internal friction and overburden, were examined by analyzing different scenarios. The findings showed that an increase in cohesion and angle of internal friction resulted in an increase in FOS, whereas an increase in unit weight and overburden caused a decrease in FOS. The influence of pore water pressure was positive to a certain extent, but a further increase led to a significant reduction in FOS. The results showed that the Miacher slope is currently stable, as all FOS values were greater than one, based on the existing strength parameters and simulated results obtained using Slope/w.

Carbonatites, which are rare mantle-derived igneous rocks that are mainly enriched in carbonate minerals and host relatively higher amounts of rare earth element (REE)-bearing phases, remain subjects of extensive geological research due to their enigmatic origin and potential economic importance. This study aims to describe the petrographic, mineralogical, and some rare-earth element (REE) abundances of four carbonatite bodies (known as Sillai Patti, Loe Shilman, Warsak, and Jambil) exposed in the Peshawar Plain Alkaline Igneous Province (PPAIP), northwestern Himalaya, Pakistan, to identify their economic potential. The observed petrographic, textural features, and chemical compositions of the constituent minerals of the carbonatites were utilized to elucidate the evolutionary processes through which the rocks evolved. The results indicate distinct mineralogical assemblages dominated by calcite, dolomite, apatite, pyroxene, biotite, and feldspar, with accessory opaque and REE-bearing phases, such as pyrochlore, monazite, and britholite. The apatite grains display compositional zoning reflecting their growth under magmatic conditions. The petrographic features of apatite in some carbonatite samples, exhibiting preferred orientation in a particular direction and spongy or murky textures, indicate that the studied rocks underwent post-magmatic deformation or hydrothermal alteration. Calcite and dolomite, coexisting in some carbonatite samples, exhibit significant Mg-Fe variation, which is possibly related to magmatic differentiation. The pyroxene compositions vary from a low-calcium enstatite–ferrosilite series to high-calcium diopside, suggesting variable crystallization environments among the carbonatite bodies studied. The abundance of REE-bearing phases in the studied carbonatites emphasizes their high economic potential. These findings indicate that the PPAIP carbonatites originated from mantle-derived magmas and subsequently experienced metamorphic/metasomatic overprinting during their tectonic evolution. The abundance of REE-rich phases such as apatite, pyrochlore, monazite, and britholite underscores their high economic potential.