Water jet technology is an effective measure by which to improve the efficiency of deep coalbed methane mining. Nevertheless, the effect of a water jet impinging on coal rock remains unclear. In this study, numerical simulation is used to analyze a water jet impingement drill test block, after which experimental verification is carried out. Next, on the basis of the experimental verification that the simulation method is feasible, the influence factors of the water jet impingement in the drill hole are analyzed. It is concluded that the phase-field variables based on the fracture change method can effectively characterize the damage and destruction of coal rock. The water jet impact in the borehole has a central damage failure zone and two-side damage failure zone, and the damage failure ratio n is used to characterize the degree of damage to the coal rock. When the jet target distance is 70 mm, the damage ratio n is closest to 1, and the effect of water jet impact on coal-rock is the best. When the wall roughness is less than 10 mm, the blocking effect on the jet is dominant, resulting in a negative correlation between the damage size and the roughness. When the wall roughness exceeds 10 mm, the development of cracks and the connection effect exceed the blocking effect, resulting in larger damage. Therefore, it can be seen that the effect of a water jet impacting on coal rock is positively related to jet pressure. When the jet target distance is 70 mm, the damage range of 30 MPa jet pressure to the center and both sides of the coal rock reaches about 1.1 m, thus signifying a good coal rock breaking effect. The wall roughness has a significant effect on the coal rock breaking effect of the water jet.
The comparative analysis of coal samples under different gas occurrence conditions systematically reveals the pore structure characteristics of coal and gas outburst coal seams. The functional relationship between R0,max and Kc was clarified using mathematical statistical methods, and the pore structure and fractal characteristics of coal and gas outburst coal seams were analyzed on the basis of modified mercury pressure data and fractal analysis. The results show that the functional relationship between R0,max and Kc is consistent with y = 1.59x−0.48, and when the mercury inlet pressure is 10~120 MPa, the coal sample is the most affected by the matrix compression effect. The average pore volume and average specific surface area of the outburst coal samples were 41.71% and 23.09%, which is greater than those of the non-outburst coal samples, respectively, and the specific surface area and pore volume provided by the outburst mining micropores were 46.24% and 81.67%, respectively. The fractal dimension, D, of the coal seam increased with the increase in metamorphism, and compared with low gas mines, the fractal dimension of coal samples in the coal and gas outburst mines was higher, the influence of the matrix compression effect was more obvious, and the heterogeneity was stronger.
The adsorption characteristics of CH4 have an important influence on gas content prediction, gas extraction, and hazard prevention. Therefore, we explored the mechanism of CH4 adsorption under the action of water and temperature to grasp the influence of water and temperature on the adsorption characteristics of CH4. In this paper, a giant, regular-system Monte Carlo method is used to simulate the CH4 adsorption behavior at the molecular level under different temperatures, water contents, and the coupling of both. The results indicate that an empirical formula for the coupling effect of temperature and water content on CH4 adsorption was obtained. The impact of different effects on CH4 adsorption is as follows: coupling effect > single temperature effect > single water content effect. The optimal combination is at a temperature of 363 K and a water content of 8.31%. Compared with the CH4 adsorption capacity without water at room temperature, the CH4 adsorption capacity is reduced by 68.04% under the coupling effect of the optimal combination. Temperature has a negative effect on the adsorption of CH4, and temperature changes the adsorption capacity by changing the average molecular kinetic energy of CH4. The reason why the increase in H2O reduces the adsorption capacity of CH4 is that the interaction between H2O and the oxygen-containing functional groups of coal is stronger than that of CH4. As the water content increases, the adsorption heat decreases, thereby inhibiting the adsorption of CH4. In addition, H2O has a smaller molecular dynamics radius as compared to CH4; the larger the free volume and surface area in the pore structure, the more adsorption pores it occupies, resulting in a more significant reduction in the adsorption of CH4.