Interfacial complexions formed by Gibbs adsorption of Ag retard the Ostwald ripening of CdTe precipitates in SnTe, minimizing the thermal conductivity. Combined with the band convergence, a high and stable zT of 1.5 is obtained in SnAg 0.05 Te-6%CdSe.
Elemental Te, as a promising mid-temperature thermoelectric material, has drawn much attention due to its distinctive band nestification and complex crystal structure. However, the poor doping efficiency and concomitant charge carrier scattering caused by the single doping/alloying method make it a challenging task to further optimize the thermoelectric performance. Herein, we demonstrate a multicomponent alloying strategy through introducing SmSe2 into a p-type Te matrix to realize the synergistic manipulation of carrier and phonon transport. This process has the following multi-functional effects: (i) precisely tuning the hole concentration to cover the optimal level; (ii) effectively weakening the reduced carrier mobility to maintain a high power factor, especially at elevated temperature; (iii) forming multi-dimensional lattice defects to enable a broad-frequency phonon scattering and consequently a noticeable suppression of lattice thermal conductivity; and (iv) improving the mechanical stability due to the pinning of dislocations. Ultimately, a high peak figure of merit zT of ∼1.06 at 600 K and an average zT as high as 0.69 (between 300 and 600 K) are achieved in Te0.985Sb0.015–2%SmSe2. The present work not only enriches the fundamental understanding on elemental Te, but also points to a new paradigm for advancing Te-related thermoelectrics with an intrinsically low thermal conductivity.
In this work the chalcopyrite CuIn3Se5−xTex (x = 0~0.5) with space group "Equation missing"<!-- image only, no MathML or LaTex --> through isoelectronic substitution of Te for Se have been prepared, and the crystal structure dilation has been observed with increasing Te content. This substitution allows the anion position displacement ∆u = 0.25-u to be zero at x ≈ 0.15. However, the material at x = 0.1 (∆u = 0.15 × 10−3), which is the critical Te content, presents the best thermoelectric (TE) performance with dimensionless figure of merit ZT = 0.4 at 930 K. As x value increases from 0.1, the quality factor B, which informs about how large a ZT can be expected for any given material, decreases, and the TE performance degrades gradually due to the reduction in nH and enhancement in κL. Combining with the ZTs from several chalcopyrite compounds, it is believable that the best thermoelectric performance can be achieved at a certain ∆u value (∆u ≠ 0) for a specific space group if their crystal structures can be engineered.