Polymer films have broad applications in different industries with specific requirements for their optical and mechanical properties. In mass production, processing conditions during film formation that apply forces and motions in various directions to the film tend to manifest preferred molecular chain orientation in the film microstructure, which unavoidably produces optical and mechanical anisotropies. In this paper, we investigate the effect of such macromolecular orientations on the optical and mechanical anisotropies of several polymer films, including polystyrene, poly(methyl methacrylate), poly(ethylene terephthalate), poly(ethylene naphthalate), poly(ether ether ketone), poly(ether sulfones), poly(ethylene chlorotrifluoroethylene), poly(phenylsulfone), and polycarbonate, at temperatures well below their respective glass transitions (Tg). The film mechanical responses, including elasticity, yielding, and post-yield behaviors, were obtained for the in- and out-of-plane directions utilizing tensile and nanoindentation testing methods, respectively. In addition, the net chain orientation within the films was evaluated by birefringence through analyzing the film optical refractive indices, which were verified and complemented by wide-angle X-ray scattering (WAXS) measurements. The results reveal a considerable quantitative correlation between the birefringence and the degree of elastic anisotropy and a qualitative correlation between the chain orientation and the film post-yield tensile instability (necking). These observations corroborate the interrelationship between the microstructure of polymer films and their optical and mechanical properties. In addition, they emphasize that process conditions can be selected to tune the optical and mechanical anisotropies to best serve the material performance in specific devices. We also propose an empirical equation to approximate the out-of-plane film stiffness based upon the optical and in-plane mechanical properties.
14 December 2021 in Journal of Engineering Materials and Technology
Polymer coatings are widely used in industrial applications. The mechanical properties of these polymer coatings are known to vary with temperature and deformation rate. The characterization of the dynamic mechanical properties of these coatings at high temperatures via traditional uniaxial testing is challenging often due to their brittleness and small size. In this paper, the mechanical properties of polymer coatings are reported with emphasis on their dynamic mechanical properties at temperatures up to 280 °C characterized by a dynamic nanoindentation technique with a sharp indenter tip. Nanoindentation was used to characterize the mechanical response with emphasis on dynamic mechanical properties of polymer coatings enclosed in a high-temperature stage. To verify the method, the viscoelastic properties of a reference polyethylene terephthalate polyester film were also characterized by uniaxial cyclic tensile testing which exhibited an excellent agreement with the proposed technique. The proposed nanoindentation method can be applied to other polymer coatings and thin films that are used in applications at high temperatures.
Colorless polyimide (PI)-based flexible cover windows are a critical component of flexible electronics to protect devices from unwanted chemical and mechanical damage. The integration of flexible colorless PI-based windows into electronics applications is limited by the embrittlement of some colorless PI films when they are coated with hard coats. Here, we investigate the embrittlement mechanism of hard-coated colorless PI films and the role of interlayers in toughening the colorless PI-based cover windows for flexible electronics applications. A fracture mechanics approach combined with finite element analysis (FEA) models is employed to compute fracture strain, εc, for different crack cases in the bilayer (hard coated colorless PI) and trilayer (with an additional interlayer) cover windows. For the model inputs and validation, the material properties of the cover windows are characterized. We show that the embrittlement is attributed to the fracture behavior of the cover windows, and placing a ductile interlayer increases the εc of colorless PI films. Using the fracture analysis as a design guide, we fabricate a trilayer cover window with an acrylic thermoset interlayer and demonstrate an improvement of the εc of the colorless PI cover window by ~42%. We believe our analysis provides insights into design guides for mechanically robust cover windows using colorless PI films and flexible HCs for emerging flexible electronics.