The effect of tempering temperature on the hydrogen embrittlement characteristics of SCM440 tempered martensitic steels was investigated in terms of their microstructure and hydrogen desorption behavior. The microstructures were characterized using scanning and transmission electron microscopy, as well as X-ray diffraction and electron backscattered diffraction analysis. Thermal desorption analysis (TDA) was performed to examine the amount and trapping behavior of hydrogen. The cementite morphology of the SCM440 tempered martensitic steels gradually changed from a long lamellar shape to a segmented short-rod shape with an increasing tempering temperature. A slow strain rate tensile test was conducted after electrochemical hydrogen charging to evaluate the hydrogen embrittlement resistance. The hydrogen embrittlement resistance of the SCM440 tempered martensitic steels increased with an increasing tempering temperature because of the decrease in the fraction of the low-angle grain boundaries and dislocation density. The low-angle grain boundaries and dislocations, which acted as reversible hydrogen trap sites, were critical factors in determining the hydrogen embrittlement resistance, and this was supported by the decreased diffusible hydrogen content as measured by TDA. Fine carbides formed in the steel tempered at a relatively higher temperature acted as irreversible hydrogen trap sites and contributed to improving the hydrogen embrittlement resistance. Our findings can suggest that the tempering temperature of SCM440 tempered martensitic steel plays an important role in determining its hydrogen embrittlement resistance.
17 May 2025 in Journal of Materials Research and Technology
This study describes how microstructural constituents affected the hydrogen embrittlement resistance of high-strength pipeline steels. The American Petroleum Institute (API) X60, X70, and X80 pipeline steels demonstrated complicated microstructure comprising polygonal ferrite (PF), acicular ferrite, granular bainite (GB), bainitic ferrite (BF), and secondary phases, e.g., the martensite-austenite (MA) constituent, and the volume fraction of the microstructures was dependent on alloying elements and processing conditions. To evaluate the hydrogen embrittlement resistance, a slow strain rate test (SSRT) was performed after electrochemical hydrogen charging. The SSRT results indicated that the X80 steel with the highest volume fraction of the MA constituent demonstrated relatively high yield strength but exhibited the lowest hydrogen embrittlement resistance because the MA constituent acted as a reversible hydrogen trap site.
6 September 2021 in Archives of Metallurgy and Materials
An artificial neural network (ANN) model was developed to predict the tensile properties of dual-phase steels in terms of alloying elements and microstructural factors. The developed ANN model was confirmed to be more reasonable than the multiple linear regression model to predict the tensile properties. In addition, the 3D contour maps and an average index of the relative importance calculated by the developed ANN model, demonstrated the importance of controlling microstructural factors to achieve the required tensile properties of the dual-phase steels. The ANN model is expected to be useful in understanding the complex relationship between alloying elements, microstructural factors, and tensile properties in dual-phase steels.
28 December 2021 in Archives of Metallurgy and Materials
The microstructure and mechanical properties of hot-rolled Fe-9Mn-0.2C medium-manganese steels with different Al, Cu, and Ni contents were investigated in this study. Based on the SEM, XRD, and EBSD analysis results, the microstructure was composed of martensite, band-type delta ferrite, and retained austenite phases depending on the Al, Cu, and Ni additions. The tensile and Charpy impact test results showed that the sole addition of Al reduced significantly impact toughness by the presence of delta-ferrite and the decrease of austenite stability although it increased yield strength. However, the combined addition of Al and Cu or Ni provided the best combination of high yield strength and good impact toughness because of solid solution strengthening and increased austenite stability.