In this paper, we address the performance optimization of Holmium doped fiber amplifier (HDFA) for optical communications in 2–2.15 μm wavelength range based on a single in-band forward pump source. The performance of the HDFA is analyzed with the help of theoretical simulations by considering an optimized length of Holmium doped fiber (HDF), doping concentration of Ho³⁺, and pump power. The impact of signal wavelength and power on gain, amplified spontaneous emission (ASE) noise, and noise figure (NF) of the amplifier is investigated. Furthermore, we investigate the variations in the gain of the amplifier, its output power, and NF by varying the power and wavelength of the pump source. After optimizing the parameters of the amplifier, the peak gain observed is around 56.5 dB, the 3 dB saturated output power obtained is 33.3 dBm, and the output power is 3 W at signal wavelength of 2.0321 μm for HDF having an optimized length of 12 m and pump power of 3.5 W. Minimum NF of around 8.2 dB is observed at 2.0321 μm for signal power of −5 dBm. The impact of ion-ion interaction on the performance of HDFA is also investigated. A reduction of 24.2 dB and 0.051 W is observed in peak gain and output power of HDFA, respectively by considering the ion-ion interaction.

Free space optics (FSO)-based optical body area networks (OBANs) are receiving massive attention as an opportunity to address the limitations of their radio frequency (RF)-based counterparts. This boom in research interests is primarily due to multitude of benefits, including high capacity, immunity to electromagnetic interference (EMI), rapid installation, cost efficiency, and license-free use of spectrum. Securing the transmission of patient health data against interception in OBANs using insecure FSO channels is a challenging task. Therefore, we propose a low-cost, flexible, and secure OBAN based on FSO technology and a time-delayed two dimensional (2D) spectral/spatial optical code-division multiple access (OCDMA) system. The proposed architecture consists of eight sensors attached to the bodies of patients. The sensors operate at a rate of 50 kbps. Electrical data generated from each sensor are used to modulate an optical carrier and then encoded using 2D-spectral/spatial double weight–zero cross correlation (DW-ZCC) code. The 2D encoded optical signals are then time delayed to eliminate the multiple parallel FSO channels between the transmitter and medical center. The combined optical signal consists of eight 2D-encoded time-delayed optical signals transmitted towards a remote medical center over an FSO channel with a range of 1 km. The received signal is decoded and the data from each sensor are recovered after photodetection at the medical center for further analysis. The overall performance of the sensors is analyzed using bit-error rate (BER) and quality factor (Q-factor) plots for different weather conditions and lengths of the FSO channel, considering the log-normal channel model. The capital expenditure (CAPEX) of the proposed architecture is analyzed and compared with the conventional 2D-spectral/spatial FSO system to determine the overall impact of introducing time delay units on the cost of implementation.