The article is devoted to the issues regarding assessment of the impact of changes in the delay in the feed direction on the dynamics of metal processing with metal-cutting machines. Here, for the first time, it is proposed that we take into account, when constructing models of the cutting control system, the real value of the delay value. It is this model that allows us to adequately consider the dynamics of the cutting process, by clarifying the effect of vibration regeneration. In this article, much attention is paid to describing the development of a measuring system that allows the calculation of the real value of the feed during cutting. It describes a series of experiments, and shows the results of data processing, using software developed by the authors. The studies conducted have shown that, in addition to the vibrations of the cutting tool in the feed direction, the vibration activity of the tool in the cutting direction plays an essential role in ensuring the regenerative effect. It should be noted that, currently, this is a new area of knowledge regarding processes in metalworking, and it requires further study.
This article discusses the issue of the joint use of neural network algorithms for data processing and deterministic mathematical models. The use of a new approach is proposed, to determine the discrepancy between data from a vibration monitoring system of the cutting process and the calculated data obtained by modeling mathematical models of the digital twin system of the cutting process. This approach is justified by the fact that some coordinates for the state of the cutting process cannot be measured, and the vibration signals measured by the vibration monitoring system (the vibration acceleration of the tip of the cutting tool) are subject to external disturbing influences. Both the experimental method and the Matlab 2022b simulation method were used as research methods. The experimental research method is based on the widespread use of modern analog vibration transducers, the signals from which undergo the process of digitalization and further processing in order to identify arrays of additional information required for virtual digital twin models. The results obtained allow us to formulate a new conceptual approach to the construction of systems for determining the degree of cutting tool wear, based on the joint use of computational virtual models of the digital twin system and data obtained from the vibration monitoring system of the cutting process.
The relation between tool wear in metal turning and the reactive forces on the tool is studied experimentally. The experimental variation of the reactive f