Integration and development of Cu Back-End of Line (BEOL) with PECVD low-k organosilicate glass (OSG, also called SiCOH, carbon-doped oxide, CDO, etc.) for 130 nm and 90 nm CMOS technologies has been reported by a number of institutions. Here we report on a Cu/SiCOH technology which has similarities, but also enhanced integration and reliability characteristics while preserving the R and C performance levels. These enhancements have led to excellent reliability results reported here, and are expected to increase the robustness to high-volume manufacturing and extendibility to next-generation smaller dimensions. The SiCOH and cap mechanical, chemical, and electrical strengths are increased, as well as associated interfacial adhesions. These combine with an optimized Cu metallization. As chip-package reliability is most at risk for low-k dielectrics, improvements have been brought into the BEOL level structure, the kerf design, and in some cases new packaging materials. When combined with the dielectric material and interface improvements, redundancy exists in the protection against potential chip-packaging failures. No failures occur in the full rounds of chip-package reliability stress testing done here on multiple wirebond and flip-chip packages. These packaging and other reliability results are presented, including BEOL-specific tests [electromigration (E-M), stress-migration (S-M), time-dependent dielectric breakdown (TDDB), thermal cycling (T/C)], environmental [temperature-humidity-bias (THB)], and functional stressing of product modules. The stress criteria and results exceeded JEDEC standards. All Cu/SiCOH tests passed at the same levels as our concurrent 90 nm Cu/SiOF technology.
This article summaries an approach for the removal of organic dyes like Congo red using mesoporous alumina. Industrial effluents that contain dyes need to be treated before being discharged into surface water.
For arsenic decontamination from groundwater, arsenic crystallization is becoming adopted due to its sustainability and economic benefits. However, arsenic crystallization technology is a two-step process, which makes it complex and generates hazardous waste. Successful efforts toward making it a single-step process are presented here. The addition of nanorods and ball-milled zinc sulfide nanoparticles to arsenic-contaminated water result in highly monodispersed and high-arsenic-containing mineralized nanowaste with a crystalline structure similar to the mineral Tooeleite ((Fe3+6(As3+O3)4SO4(OH)4·4H2O)). This study reports the results of a short-term stability test based on a toxicity characteristic leaching procedure and a long-term stability test of the mineralized synthetic nanowaste produced from water treatment. The Tooeleite-like mineralized nanowaste passed short-term stability tests. Arsenic in the leachate were found to be 1.1 ± 0.2 mg L−1 and 4.8 ± 0.3 mg L−1 from waste generated by the nanorod and ball-milled nanoparticles, respectively. The crystallinity was well preserved, as observed from the post-stability-test diffraction patterns, consequently proving that the waste product can be non-hazardous and therefore would not require any secondary treatment before final disposal.