High-temperature proton exchange membrane fuel cells (HT-PEMFCs) offer distinct advantages over their low-temperature counterparts. However, their commercial viability is significantly hampered by durability challenges stemming from electrocatalyst support degradation in the corrosive phosphoric acid environment. This review provides a comprehensive analysis of advanced strategies to overcome this critical durability issue. Two main research directions are explored. The first involves engineering more robust carbon-based materials, including graphitized carbons, carbon nanostructures (nanotubes and graphene), and heteroatom-doped carbons, which enhance stability by modifying the carbon’s intrinsic structure and surface chemistry. The second direction focuses on replacing carbon entirely with intrinsically stable non-carbonaceous materials. These include metal oxides (e.g., TiO2, SnO2), transition metal carbides (e.g., WC, TiC), and nitrides (e.g., Nb4N5). For these non-carbon materials, a key focus is on overcoming their typically low electronic conductivity through strategies such as doping and the formation of multi-component composites. The analysis benchmarks the performance and durability of these advanced supports, concluding that rationally designed composite materials, which combine the strengths of different material classes, represent the most promising path toward developing next-generation, long-lasting catalysts for HT-PEMFCs.
Platinum supported on carbon support (Pt/C) is currently the most common and practicable electrocatalyst for the real application of polymer electrolyte membrane fuel cells (PEMFCs). In this work, it was found that the nature of a reducing agent has noteworthy influence on Pt nanoparticles growth and distribution over acid-treated-Vulcan carbon support (Pt/AT-VC), which was employed to catalyze the oxygen reduction reaction (ORR) for PEMFC. Three distinct reducing agents, i.e., sodium borohydride (BH), sodium citrate (CA), and formaldehyde (FMY), were employed for Pt/AT-VC preparation through the impregnation-reduction approach. The impacts of the reducing agent on Pt nanoparticles size and its distribution over carbon support were scrutinized by X-ray diffraction (XRD) and high-resolution transmission electron microscopy (TEM) techniques. The electrocatalytic performance for ORR was subsequently studied by a three-electrode setup with rotating ring-disc electrode (RRDE) characterization and practical fuel cell operation. The ORR kinetics and mechanism were confirmed from RRDE, and it was well correlated with the durability test and single-cell results. Based on the results, the catalysts’ performances for practical PEMFC can be arranged in the order of Pt/AT-VC (BH) < Pt/AT-VC (CA) < Pt/AT-VC (FMY), implying the significance of selecting the reducing agent for the preparation of Pt/C for PEMFC real application.
Methanol crossover is an important factor affecting the performance of direct methanol fuel cells (DMFCs). In this work, a novel membrane electrode assembly (MEA) is designed and prepared by adding a layer of graphene aerogel (GA) between the carbon powder microporous layer and the catalytic layer, which optimizes the methanol transport and improves the output performance of DMFC at high methanol concentrations. Compared to conventional carbon powder, the addition of GA increases the tortuosity of the anode in the through-plane direction; hence, methanol is diluted to a suitable concentration when it reaches the catalyst. The maximum power density of the novel MEA can reach 27.4 mW·cm−2 at a condition of 8 M methanol, which is 234% higher than that of the conventional electrode. The test results of electrochemical impedance spectroscopy (EIS) indicate that the addition of GA does not increase the internal resistance of the novel MEA and that the mass transfer resistance at high concentrations is significantly lower. The experimental results indicate that the output performance at high concentration can be significantly improved by adding a GA layer, and its practicability in portable devices can be improved. It also improves the stability of DMFC under long-term testing.