Jinfei Sun

Dr. Jinfei Sun


Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2017 in Procedia Engineering
Verified
Journal Article
Open access
YYYingde Yin
Yingde Yin
DZDongsheng Zhu
Dongsheng Zhu
JSJinfei Sun
Jinfei Sun
XLXiuzhen Li
Xiuzhen Li
TATu Aimen
Tu Aimen

25 May 2023 in Heliyon
Verified
Journal Article
Open access
JSJinfei Sun
Jinfei Sun
JGJianxiang Guo
Jianxiang Guo
LHLongbin He
Longbin He
SHShengjun Hou
Shengjun Hou
ZYZhengchang Yu
Zhengchang Yu
Two major problems for the vapor injection heat pump systems with the flash tank are the high discharge temperature and the lack of flash tank design theoretical basis, which would limit its wide application in extreme operating conditions. One possible way to overcome these problems is to effectively control the two-phase injection in the flash tank by optimizing its structure. The use of the proposed novel flash tank in the quasi-two-stage vapor injection cycle represents an economic and controllable solution. This research experimentally analyzes the influences of flash tank structure and volume on the system heating performance under different compressor frequencies and injection pressures at the ambient temperature of −10 °C. The comparative analysis is done finding that the novel flash tank could maximumly improve the system Coefficient of Performance (COPh) by 6.4% in this test, compared with the traditional type A flash tank cycle. In the meanwhile, a bad design of novel flash tank size could represent a loss of COPh improvement between 5.73% and 13.5%. Due to the particular structure, the implementation of the novel flash tank also allows the injection mass flow ratio can keep a linear relationship with the injection pressure. Moreover, the refrigerant liquid can be regularly injected into the compression chamber to control discharge temperature under 100 °C. From all the analysis, guidelines for optimizing the control strategy and the flash tank design are put forward, which can be used to perfect the real thermodynamic model of the flash tank rather than the ideal two-phase separation model.

25 September 2023 in Energies
Verified
Journal Article
Open access
PDF file
JSJinfei Sun
Jinfei Sun
ZRZhengen Ren
Zhengen Ren
JGJianxiang Guo
Jianxiang Guo
To manage energy-efficient indoor air quality, mechanical ventilation with a heat recovery system provides an effective measure to remove extra moisture and air contaminants, especially in bathrooms. Previous studies reveal that heat recovery technology can reduce energy consumption, and its calculation needs detailed information on the thermal performance of exhaust air. However, there are few studies on the thermal performance of bathroom exhaust air during and after showers. This study proposed a detailed thermal performance prediction model for bathroom exhaust air based on the coupled heat and mass transfer theory. The proposed model was implemented into the AccuRate Home engine to estimate the thermal performance of residential buildings with heat recovery systems. The time variation of the water film temperature and thickness on the bathroom floor can be estimated by the proposed model, which is helpful in determining whether the water has completely evaporated. Simulation results show that changing the airflow rate in the bathroom has little effect on drying the wet floor without additional heating. The additional air heater installed in the bathroom can improve floor water evaporation efficiency by 24.7% under an airflow rate of 507.6 m3/h. It also demonstrates that heat recovery can significantly decrease the building energy demand with the fresh air load increasing and contribute about 0.6 stars improvement for the houses in Hobart (heating-dominated region). It may be reduced by around 3.3 MJ/(m2·year) for the houses in other regions. With this study, guidelines for optimizing the control strategy of the dehumidification process are put forward.