Jianxiang Guo

Jianxiang Guo


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 May 2023 in Heliyon
Verified
Journal Article
Open access
JSJinfei Sun
Jinfei Sun
JGJianxiang Guo
Jianxiang Guo
LHLongbin He
Longbin He
SHShengjun Hou
Shengjun Hou
ZYZhengchang Yu
Zhengchang Yu
Two major problems for the vapor injection heat pump systems with the flash tank are the high discharge temperature and the lack of flash tank design theoretical basis, which would limit its wide application in extreme operating conditions. One possible way to overcome these problems is to effectively control the two-phase injection in the flash tank by optimizing its structure. The use of the proposed novel flash tank in the quasi-two-stage vapor injection cycle represents an economic and controllable solution. This research experimentally analyzes the influences of flash tank structure and volume on the system heating performance under different compressor frequencies and injection pressures at the ambient temperature of −10 °C. The comparative analysis is done finding that the novel flash tank could maximumly improve the system Coefficient of Performance (COPh) by 6.4% in this test, compared with the traditional type A flash tank cycle. In the meanwhile, a bad design of novel flash tank size could represent a loss of COPh improvement between 5.73% and 13.5%. Due to the particular structure, the implementation of the novel flash tank also allows the injection mass flow ratio can keep a linear relationship with the injection pressure. Moreover, the refrigerant liquid can be regularly injected into the compression chamber to control discharge temperature under 100 °C. From all the analysis, guidelines for optimizing the control strategy and the flash tank design are put forward, which can be used to perfect the real thermodynamic model of the flash tank rather than the ideal two-phase separation model.

20 February 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
HWHao Wan
Hao Wan
XWXinyu Wang
Xinyu Wang
FMFengqiang Miao
Fengqiang Miao
DRDongdong Ren
Dongdong Ren
XZXiangming Zhao
Xiangming Zhao
FXFeng Xu
Feng Xu
Carbon-based material adsorption is one of the research hotspots in the Carbon Capture, Utilization, and Storage (CCUS) field, and its surface functional groups have a significant impact on CO2 adsorption performance. This study uses Density Functional Theory (DFT) methods to explore the adsorption mechanism of CO2 on the surface of carbon-based materials by examining changes in parameters such as adsorption energy before and after the reaction process. It also studies the influence of different functional groups on the surface of carbon-based materials on CO2 adsorption performance. Research shows that under different doping conditions, the adsorption energy of CO2 on carbon-based materials can be roughly divided into three levels: when both C=C and C=O double bonds are formed, the adsorption energy reaches the highest level; the structure with the C–N single bond accompanied by the C=O double bond reduces the adsorption energy by one level; and when only C=C double bonds exist, the adsorption energy is at the lowest level. Meanwhile, the incorporation of functional groups such as N, NH+ and O2 will reduce the adsorption energy of carbon-based materials for CO2 to varying degrees. Notably, N and NH+ modification not only introduces new nitrogen active sites but also optimizes material performance while maintaining a relatively high adsorption capacity, thus demonstrating good modification potential.

25 September 2023 in Energies
Verified
Journal Article
Open access
PDF file
JSJinfei Sun
Jinfei Sun
ZRZhengen Ren
Zhengen Ren
JGJianxiang Guo
Jianxiang Guo
To manage energy-efficient indoor air quality, mechanical ventilation with a heat recovery system provides an effective measure to remove extra moisture and air contaminants, especially in bathrooms. Previous studies reveal that heat recovery technology can reduce energy consumption, and its calculation needs detailed information on the thermal performance of exhaust air. However, there are few studies on the thermal performance of bathroom exhaust air during and after showers. This study proposed a detailed thermal performance prediction model for bathroom exhaust air based on the coupled heat and mass transfer theory. The proposed model was implemented into the AccuRate Home engine to estimate the thermal performance of residential buildings with heat recovery systems. The time variation of the water film temperature and thickness on the bathroom floor can be estimated by the proposed model, which is helpful in determining whether the water has completely evaporated. Simulation results show that changing the airflow rate in the bathroom has little effect on drying the wet floor without additional heating. The additional air heater installed in the bathroom can improve floor water evaporation efficiency by 24.7% under an airflow rate of 507.6 m3/h. It also demonstrates that heat recovery can significantly decrease the building energy demand with the fresh air load increasing and contribute about 0.6 stars improvement for the houses in Hobart (heating-dominated region). It may be reduced by around 3.3 MJ/(m2·year) for the houses in other regions. With this study, guidelines for optimizing the control strategy of the dehumidification process are put forward.

3 February 2026 in Buildings
Verified
Journal Article
Open access
PDF file
JZJinqin Zhong
Jinqin Zhong
JSJufeng Shu
Jufeng Shu
JGJianxiang Guo
Jianxiang Guo
Jianheng ChenJianheng Chen
Jianheng Chen
XZXiangming Zhao
Xiangming Zhao
Yelin ZhangYelin Zhang
Yelin Zhang
Regional Integrated Energy Systems (RIESs) are pivotal in the low-carbon transition of energy-intensive hospital campuses. However, traditional multi-objective optimization for RIES planning often suffers from the subjective selection of weights, leading to configurations that lack robustness against varying decision-maker preferences. To address this, this paper proposes a robust optimization methodology integrating shadow cost theory and multi-scenario weight scanning. A high-fidelity dynamic simulation model of a hospital in Beijing was constructed using TRNSYS. By monetizing environmental externalities into shadow costs, a comprehensive objective function, including annual cost savings rate, primary energy savings rate, and environmental shadow cost savings rate, was established, and the Hooke–Jeeves algorithm was employed to scan ten distinct weight scenarios, ranging from profit-driven to eco-centric preferences. The results reveal that solar collectors lack economic competitiveness under current boundary conditions due to cooling–heating coupling constraints. Instead, a configuration featuring a large-capacity gas turbine (2790 kW) coupled with a moderate GSHP was identified as the optimal solution in over 80% of the scenarios, demonstrating high preference robustness. Crucially, this configuration achieves net-negative emissions by maximizing clean power exports to displace carbon-intensive grid electricity. Compared to the reference system, the optimized RIES reduces primary energy consumption by 82.7% and achieves substantial environmental benefits, subject to grid emission factors. These findings confirm that prioritizing clean power export is a resilient pathway for hospitals to balance economic feasibility with environmental goals under current policy frameworks, providing scientific guidance for policymakers and engineers.

23 March 2026 in Catalysis Letters
Verified
Journal Article
Closed access
PDF file
DRDongdong Ren
Dongdong Ren
FMFengqiang Miao
Fengqiang Miao
XWXinyu Wang
Xinyu Wang
HWHao Wan
Hao Wan
DYDongji Yang
Dongji Yang
JGJianxiang Guo
Jianxiang Guo

22 September 2024 in Catalysis Letters
Verified
Journal Article
Closed access
PDF file
JZJinqin Zhong
Jinqin Zhong
ZLZi-Peng Li
Zi-Peng Li
DRDongdong Ren
Dongdong Ren
JGJianxiang Guo
Jianxiang Guo
JWJi-Jin Wang
Ji-Jin Wang
NLNa Liu
Na Liu