Joanna Wyczarska-Kokot

Prof. Dr. Joanna Wyczarska-Kokot

Department of Water and Wastewater Engineering, Silesian University of Technology, Gliwice, Śląskie, Poland
orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 October 2020 in Environmental Monitoring and Assessment
Verified
Journal Article
Open access
PDF file
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
ALAnna Lempart-Rapacewicz
Anna Lempart-Rapacewicz
MDMariusz Dudziak
Mariusz Dudziak
EŁEdyta Łaskawiec
Edyta Łaskawiec
Recommendations regarding disinfection by-products (DBPs) in pool waters consider the content of trihalomethanes (THMs) and combined chlorine (CC) as indicators of DBPs based on which the health risk for swimmers and staff of pool facility can be determined. However, the content of DBPs in swimming pools depends on many factors. In this paper, the influence of selected factors (physicochemical parameters of water and technological parameters) on the content of THMs and CC in pool water was determined. During the 6-month period, 9 pools of various functions were analyzed. The water in pools was subjected to the same method of treatment. The content of THMs and CC was compared against the content of organic matter, free chlorine and nitrates, pH, temperature, redox potential and turbidity, technological, and operational parameters. The THM content did not exceed the limit value of 0.1 mg/L. The content of CC varied significantly, from 0.05 to 1.13 mg Cl2/L. It was found that a very large water volume per person, in comparison to a very small one, contributed to the low content of CC and THMs. The high load expressed as m3 of water per person or m2 of water per person and the specific function of hot tubs (HT1 and HT2) led to the average concentration of CC in these pools exceeding 0.3 mg Cl2/L. The THM concentrations in hot tubs (especially in HT1) were also among the largest (0.038–0.058 mg/L). In terms of the analyzed microbiological indicators, the quality of the tested pool water samples was not in doubt. It was found that the purpose of the pool, its volume, and number of swimmers should be the key parameters that determine the choice of methods of water treatment. The research on the pool water quality in the actual working conditions of swimming pool facilities is necessary due to the need to preserve the health safety of swimmers and staff.

1 July 2017 in Journal of Ecological Engineering
Verified
Journal Article
Open access
EŁEdyta Łaskawiec
Edyta Łaskawiec
MDMariusz Dudziak
Mariusz Dudziak
MMMarta Madej
Marta Madej
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
The paper has determined the suitability of membrane processes (UF ultrafiltration, UF, and nanofiltration, NF) for the purification of waste streams, so-called backwash water, obtained from washing filtration beds in a swimming pool water system. The backwash water samples were taken from the...

25 March 2019 in Membranes
Verified
Journal Article
Open access
PDF file
MDMariusz Dudziak
Mariusz Dudziak
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
EŁEdyta Łaskawiec
Edyta Łaskawiec
ASAgnieszka Stolarczyk
Agnieszka Stolarczyk
Swimming pool water was treated using an ultrafiltration process using ceramic and polymer membranes for comparison. It was determined that the efficiency of the process depended on the type of membrane used. The polymer membrane decreased the absorbance and concentration of combined chlorine in the pool water to a greater extent than the ceramic membrane. In the case of a ceramic membrane, the concentration of combined chlorine in the permeate exceeded the limit values. During the ultrafiltration process, the permeate flux decreased, causing the blockage of membrane pores. The extent of this phenomenon was similar for both tested membranes. In the case of the ceramic membrane, flushing it with water could significantly restore its initial performance. For both tested membranes, a high regeneration efficiency was observed during chemical treatment with an alkaline solution. SEM photos of the polymer membrane showed low resistance of this polymer to the chlorine present in the swimming pool water.

21 January 2020 in Water
Verified
Journal Article
Open access
PDF file
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
ALAnna Lempart-Rapacewicz
Anna Lempart-Rapacewicz
MDMariusz Dudziak
Mariusz Dudziak
The analysis of free chlorine concentrations in swimming pool water makes it possible to assess the antiseptic effect of the disinfectant. The concentration of combined chlorine determines the comfort of swimming and indicates if there is a threat from DBP (disinfection by-products). The distribution of free and combined chlorine concentration was analyzed in four basins differing in seasonality of use and in the applied water flow systems. After considering the distribution of free and combined chlorine content in characteristic points of pools, an attempt was made to determine the most reliable point for assessing the quality of water and its suitability for swimming. Such searches should aim to identify the places with the worst water quality. The most uniform distribution of the concentrations of both free and combined chlorine was observed at the middle point of swimming pools, while at points near the corners and walls of swimming pools a varied distribution was observed. Such a control strategy, based on the least favorable test results at a point considered as characteristic, would make it possible to verify the parameters of the swimming pool water treatment system and thus minimize the risk to swimmers’ health.

1 November 2022 in Desalination and Water Treatment
Verified
Journal Article
Open access
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
MDMariusz Dudziak
Mariusz Dudziak

1 September 2016 in Ecological Chemistry and Engineering S
Verified
Journal Article
Open access
PDF file
JWJoanna Wyczarska-Kokot
Joanna Wyczarska-Kokot
Swimming pools are very expensive, in terms of operation, sports facilities. Therefore, investors and managers of these facilities are looking for methods of reducing the costs of their use. One of the proposed methods is the managing of washings previously discharged to the sanitary sewage system. The assessment of possibilities for reuse of washings from swimming pool filtration system is based on the limits of basic indicators of pollutants in wastewater discharged to water and soil (temperature, pH, TSS, BOD5, COD, TN, TP, free chlorine). The conducted research of washings quality from 26 tested swimming pools have shown that washings quality is dependent on the operating conditions of the pool circuit, including the filter cycle duration and types of filter bed. A direct discharge to water or soil may be impossible due to excessive amounts of total suspended solids (above 35 mg/dm3) and free chlorine concentration (above 0.2 mg Cl2/dm3). However, the quality of supernatant water of washings subjected to sedimentation in the laboratory shows that the washings are suitable for reuse. The installation of settling tanks in swimming pool facilities could relieve the sewage systems and allow for the discharge of supernatant water to surface waters or for the irrigation of green areas in an environmentally friendly way.