The wave period is a wave parameter that is significantly influenced by factors such as wind speed and bottom topography. Previous research on wave period parameterization has primarily focused on wind-dominated sea areas and may not be applicable to certain regions, such as the equatorial calm or coastal areas dominated by swell waves. To address this limitation, this paper utilizes the third-generation wave numerical model SWAN to perform wave numerical simulations for a portion of the Northwest Pacific Ocean. The simulation incorporates observational data from nearshore stations, buoys, and satellite altimeters for error analysis. To develop a new wave parameterization scheme (WS-23), we employ extensive NDBC buoy data and incorporate the exponential rate and wave age characteristics that were previously established by predecessors. Our scheme introduces a judgement mechanism to distinguish between wind waves, swell waves, and mixed waves. The resulting ocean wave factor enhances the mean wave period values calculated using the model and other parameterization schemes. The experimental results demonstrate that our new parameterization scheme effectively improves the abnormal peak of the fitting data. Comparing the output values of the mean wave period element output of the SWAN model with our new parameterization scheme, we observe a reduction in the mean values of $E_a$, $E_c$, and $RMSE$ by 0.231, 1.94%, and 0.162, respectively, while increasing the average $r$ by 0.05.

Waves are one of the most important dynamic phenomena in the ocean, and thus numerical simulations of ocean wave is of great importance. Based on SWAN wave numerical model, this paper simulates the waves in the Northwest Pacific Ocean and analyzes the wave height field in the sea area. Moreover, A new wave period parameterization scheme is proposed according to the relationship between the wave height and wave period, in addition, the simulation mode of wave period elements in the Northwest Pacific Ocean is optimized by analyzing the difference of wave period under the proposed parameterization scheme.

Radiation stress is defined as the excess momentum caused by ocean waves, which exerts an indispensable impact on the upper-layer ocean conditions as waves pass by. Previous research concentrated on sea surface cooling caused by typhoons. In this paper, we investigated the effect of wave-induced radiation stress on upper-layer ocean temperature (including sea surface temperature (SST) and mixed-layer temperature) under typhoon conditions, as well as the effect of radiation stress on the surface current field. The FVCOM-SWAVE model, which is based on the SWAN model, is used to simulate the response of upper-layer ocean temperature to radiation stress. The simulated results, when validated with Jason-3 satellite and ARGO data, could reproduce the observed phenomenon well in general. Compared to simulations without radiation stress, the bias in the SST results is reduced by about 1 °C if the radiation stress term is taken into account. The mixed-layer depth temperature is expected to be simulated more accurately, with a root mean square error (RMSE) of less than 1.63 °C and a correlation coefficient (COR) of about 0.94. Results show that wave-induced radiation stress enhances the surface current and causes certain deviations to the right so that the upper water diverges and upwelling increases, resulting in a decrease in SST. When the influence of double typhoons is considered, the airflow of LEKIMA(L) rotates from the northwest toward KROSA (R), limiting the development of significant wave height (SWH) and reducing the cooling range. As a result, the present study is of tremendous importance in precisely forecasting the ocean state of the western North Pacific (WNP).

Wave-induced radiation stress (RS), as a primary driver of ocean currents influenced by waves, plays an important role in the response of upper ocean temperatures under typhoons. Previous studies have mainly focused on wave-generated currents and coastal currents in nearshore areas. This paper incorporates the geostrophic effect into the wave-induced radiation stress of wave-current interaction, and the effect of waves on the changes in upper ocean temperature (including sea surface temperature (SST) and mixed layer temperature) under typhoon Nanmadol (2022) is studied. The FVCOM-SWAVE model is used to conduct a preliminary numerical study in the western Pacific Ocean. The RS with the geostrophic effect increased the horizontal and vertical components, leading to an enhancement in turbulent mixing and a decrease in SST by up to 1.0 °C to 1.4 °C, which is closer to the SST obtained by OISST remote sensing fusion observation data. In the strong divergence domain, the direction of the vortex flow exhibits a more pronounced turn to the right, accompanied by an increase in water velocity. The vertical temperature profile of the ocean shows that the water below is perturbed by the RS component of the geostrophic effect, and the depth of the mixed layer increases by about 2 m, which is closer to the depth of the mixed layer observed by the Argo floats, indirectly enhancing the vertical mass transport of the ocean. In general, this shows that RS, which takes into account geostrophic effects, enhances the effect of waves on the water below, indirectly leading to lower temperatures in the upper ocean, and the simulated results align more closely with the observed data, offering valuable insights for enhancing marine numerical forecasting accuracy.