This article presents 10 tests on a self-centering Sliding Hinge Joint (SHJ) subassembly. The flexural capacity was generated with a combination of ring springs and Asymmetric Friction Connections, with the proportion varied between tests. The joints produced stable and repeatable hysteretic behavior and minimal damage to the floor slab, with self-centering capability improving with increasing ring spring contribution. There was negligible difference between tests undertaken at static and seismic-dynamic rates of loading. The SHJ had a 20% reduction in strength under a near fault pulse type motion. A simple mathematical model of the SCSHJ rotational behavior is also developed.
2 December 2014 in Earthquake Engineering & Structural Dynamics
This paper describes experimental testing of an asymmetric friction connection (AFC) at the base of a steel column such as may be used in a moment-frame. Friction/sliding surfaces were parallel to the column-strong axis. In-plane, out-of-plane and 2D clover leaf–cyclic tests were conducted of columns both with and without applied axial force. Tests were conducted both with and without bolts passing through the plates to provide compression on the sliding/friction interface. It was found that this type of rocking base–friction connection can tolerate high levels of drift without significant strength degradation, although some stiffness degradation occurred, especially after the cycles in the weak-axis direction. A simple procedure proposed to estimate the moment resistance is verified. The friction-base connections, having similar cost to conventional connections and exhibiting low-damage performance, have the potential to become widely used in aseismic construction.