Current catalysts face challenges with low formate selectivity at high current densities during the CO2 electroreduction. Here, we showcase a versatile strategy to enhance the formate production on p-block metal-based catalysts by incorporating noble metal atoms on their surface, refining oxygen affinity, and tuning adsorption of the critical oxygen-bound *OCHO intermediate. The formate yield is observed to afford a volcano-like dependence on the *OCHO binding strength across a series of modified catalysts. The rhodium-dispersed indium oxide (Rh/In2O3) catalyst exhibits impressive performances, achieving Faradaic efficiencies (FEs) of formate exceeding 90% across a broad current density range of 0.20 to 1.21 A cm−2. In situ Raman spectroscopy and theoretical calculations reveal that the oxophilic Rh site facilitates *OCHO formation by optimizing its adsorption energy, placing Rh/In2O3 near the volcano-shaped apex. A bipolar electrosynthesis system, coupling the CO2 reduction at the cathode with the formaldehyde oxidative dehydrogenation at the anode, further boosts the FE of formate to nearly 190% with pure hydrogen generation under an ampere-level current density and a low cell voltage of 2.5 V in a membrane electrode assembly cell.
1 October 2022 in Journal of the Electrochemical Society
The electrochemical CO 2 or CO reduction to chemicals and fuels using renewable energy is a promising way to reduce anthropogenic carbon emissions. The gas diffusion electrode (GDE) design enables low-carbon manufacturing of target products at a current density (e.g., 500 mA cm −2 ) relevant to industrial requirements. However, the long-term stability of the GDE is restricted by poor water management and flooding, resulting in a significant hydrogen evolution reaction (HER) within almost an hour. The optimization of water management in the GDE demands a thorough understanding of the role of the gas diffusion layer (GDL) and the catalyst layer (CL) distinctively. Herein, the hydrophobicity of the GDL and CL is independently adjusted to investigate their influence on gas transport efficiency and water management. The gas transport efficiency is more enhanced with the increase in hydrophobicity of the GDL than the CL. Direct visualization of water distribution by optical microscope and micro-computed tomography demonstrates that the water flow pattern transfers from the stable displacement to capillary fingering as GDL hydrophobicity increases. Unfortunately, only increasing the hydrophobicity is not sufficient to prevent flooding. A revolutionary change in the design of the GDE structure is essential to maintain the long-term stability of CO 2 /CO reduction.
7 September 2022 in International Journal of Hydrogen Energy
In situ spectroscopies reveal the increase of Fe and Ni valence states during oxygen evolution in anion-exchange-membrane water electrolyzers (AEMWE) for hydrogen production.
In the past few decades, tremendous attention has been devoted to enhancing the activity of oxygen evolution reaction (OER) catalysts for hydrogen production, while the cost and long-term stability of catalysts, which can play an even more important role in industrialization, have been much less emphasized. Herein, we engineered an OER electrode from abundant stainless steel (SS) via facile approaches, and the obtained electrode consists of a Ni-rich oxide surface layer with a Fe-rich metal substrate. An outstanding activity was observed with an overpotential of 316 mV at 100 mA cm−2 in 1 M KOH electrolyte. Additionally, an electrode self-replenishing concept is proposed in which a Ni-rich catalyst layer can be regenerated from a metallic substrate due to the difference in diffusion and dissolution rates of metal oxides/hydroxides, and this regeneration is validated by various characterizations. A recorded degradation rate of 0.012 was observed at 1000 mA cm−2 for 1000 h. The facile engineering of OER electrodes from SS combined with the self-replenishing catalyst can potentially address the cost, activity, and long-term stability barriers.