Ivy Ann Razonado

Ms. Ivy Ann Razonado

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
HPHazel Peniche
Hazel Peniche
IRIvy Ann Razonado
Ivy Ann Razonado
PAPierre Alcouffe
Pierre Alcouffe
GSGuillaume Sudre
Guillaume Sudre
CPCarlos Peniche
Carlos Peniche
LDLaurent DAVID
Laurent DAVID
We designed and characterized chitosan–caseinate fibers processed through wet spinning for biomedical applications such as drug delivery from knitted medical devices. Sodium caseinate was either incorporated directly into the chitosan dope or allowed to diffuse into the chitosan hydrogel from a coagulation bath containing sodium caseinate and sodium hydroxide (NaOH). The latter route, where caseinate was incorporated in the neutralization bath, produced fibers with better mechanical properties for textile applications than those formed by the chitosan–caseinate mixed collodion route. The latter processing method consists of enriching a pre-formed chitosan hydrogel with caseinate, preserving the structure of the semicrystalline hydrogel without drastically affecting interactions involved in the chitosan self-assembly. Thus, dried fibers, after coagulation in a NaOH/sodium caseinate aqueous bath, exhibited preserved ultimate mechanical properties. The crystallinity ratio of chitosan was not significantly impacted by the presence of caseinate. However, when caseinate was incorporated into the chitosan dope, chitosan–caseinate fibers exhibited lower ultimate mechanical properties, possibly due to a lower entanglement density in the amorphous phase of the chitosan matrix. A standpoint is to optimize the chitosan–caseinate composition ratio and processing route to find a good compromise between the preservation of fiber mechanical properties and appropriate fiber composition for potential application in drug release.

3 June 2020 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
IRIvy Ann Razonado
Ivy Ann Razonado
ESEmee Grace T. Suarnaba
Emee Grace T. Suarnaba
LMLawrence V. Madriaga
Lawrence V. Madriaga
LDLeslie Joy L. Diaz
Leslie Joy L. Diaz
Nowadays, there is a need for efficiency and miniaturization in electronic products. However, in the chip level, heat dissipation can limit the performance of these gadgets. Semiconductor industries addressed this thermal management challenge by using thermal interface material. Previous studies have shown that polymer-clay nanocomposite has an enhanced thermal conductivity which can be used as a thermal interface material. In this study, the aim was to determine the effect of casting techniques on the microstructure and thermal conductivity of the polymer-clay nanocomposites. Solution intercalation method was used in fabricating the 5vol% polymer-clay nanocomposite. Organo-modified montmorillonite (MMT) was dispersed in unsaturated polyester (UP) matrix by means of high frequency ultrasonication and formed using two casting techniques; mold casting and tape casting. Results showed a slight increase in the thermal conductivity coefficient of the tape-casted samples at 2.99 W/m-K compared to the mold-casted samples at 2.87 W/m-K. Transmission electron microscopy (TEM) and x-ray diffraction (XRD) results exhibited dispersed microstructure for both casting techniques. Polymer intercalation of ~16% increase in d-spacing of clay for mold-casted samples and with a ~20% increase in d-spacing of clay for tape-casted samples were observed. With these microstructure modifications, the increase in the thermal conductivity coefficient of the tape-casted samples can be attributed to the shear force employed by the tape casting technique.